WHICH CENTER PIN FOR MECH MODS

[Thuen]

I recently tried out mech mods, and i currently run the Asguard mini with the Tauren 21700 mech mod.
Included in the package for the Asguard there is a copper center pin with a flat head. Should i use that on my mech mod or just screw in the small screw on the gold center pin to block the squonk mode ?

 

[ShowMeTwice]

You do not want to use a squonk pin on a non squonking mech mod.

If the Asguard Mini RDA came with a blind pin use that for dripping. From what I read there should be a screw that gets installed in the 510 pin to use it as a dripper.

The Asguard Mini RDA was designed for squonking versus dripping.

Watch that 510 screw though. It is very likely that some juice may still get through. I have a KRMA RDA which uses a similar setup and some juice always seeps through. I won't use an RDA like that for dripping. It only goes on my squonkers.

For dripping you would be better off finding/using an RDA that has an actual blind 510 pin included.

Good luck!

 

[mimöschen]

If you have a solid 510-pin for your RDA, then it's highly advisable to use that with your non squonking mods instead of the squonk pin.
Plugged or not, squonk pins always leak into the inside of the mod and possibly onto your battery or chipset if it's a regulated device.
You absolutely do not want that.