Whoops! I've got a problem!

[TxParamedic]

After a few hours of blissful vaping my newly acquired Chuck it just stopped working! One problem is I only have one atty so I can't rule that out as the problem. When I took the atty off there was a little juice on the connector (I'm dripping) I cleaned that up with a qtip. the center post looked a bit off kilter so I straitend it out with a paper clip. (Is the center connector supposed to wiggle around inside the post?) The Batts are good I tried them in another device. Sooooo any suggestions?

 

[Chime]

This may sound dumb, but assuming the bats are good, try turning the push button (like the top part only with your fingers).

 

[TxParamedic]

Switch twisting and batt charging didn't fix the problem. I'll have to order another atty to rule out atty failure. If it still doesnt fire I may have to send it in. I still think I made a good trade I'm gonna love this mod when I get the kinks worked out. I guess I should expect a little static from a used mod.

 

[AmyB66]

Well, look at it this way, you can send it in, get a new switch and get the hole drilled on your endcap at the same time! You can take a qtip dipped in a tiny bit of rubbing alcohol and clean the switch, it just might be gunk. Careful not to get the alcohol on your paint/graphics as that can wreck it.
Its a bit of a last resort fix, it either works or it doesn't.

 

[TxParamedic]

Thanks Amy, I guess I'll have to wait till I get an atty in the mail to know for sure if I need to. If it is the atty can I just order a new end cap?

 

[TxParamedic]

Yay! It's the atty. I put one of my old 808 carts on the Chuck and it fired right up. Now I just have to wait for my order from madvapes to come in and I'm back in bidness with Mr. Chuck!