• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

Why do i keep getting my wick burnt?

Status
Not open for further replies.

chia

Super Member
ECF Veteran
Verified Member
Nov 7, 2014
892
494
Red Dot
I had this issue a lot before I started building with spaced coils and Scottish roll wicking method. Do try it out.

I figured most of the time it's the coil heating up unevenly on tight wicks.
Tried again just now.. Coil glowing inside out. I'm using rayon, so I lightly pull the strands apart to as thin as possible, then roll it back like the Scottish roll.
Took some continuous(4-5) extended long DLH with no problems at all ;) thanx for the reminder:)
 

Fireryfir

Full Member
Aug 4, 2016
7
0
41
Singapore
Im using an ipv mini 2 with subox mini tank. vaping at 18-20 watts on a 0.6ohm coil.

When i check, its only burnt on one side of the wick. Any tips on wicking?


Sent via Prehistoric Stone Tablet
Try checking if ur coil is even. To do so dismantle ur tank and in the rda section use a screwdriver give it a few rubs on the coil and hit the fire button. U shd be getting an even glow in ur coil. Hope that answer ur question.
 
Status
Not open for further replies.

Users who are viewing this thread