Will the Tobeco Aqua clone thread into the Tobeco Origin clone for hybrid mode?
- Thread starter Sam McMillan
- Start date
- th_trl_thread_readers 0
- Status
From what I hear it only threads on the brass origin without 2nd pin. If you have a tobeco aqua it won't come with the hybrid pin. You also need the hybrid 2nd pin if your using it with a SS version. I have brass origin and it supposedly is shorter than SS version, so hybrid mode you don't need the 2nd pin. If you're just wondering if it fits on any origin mod the answer is YES.
Yes it will thread onto the SS version of the Origin clone by tobeco, I have both. The problem I had was with the connector pin, alot of people did not receive one with their Aqua clone. I bought mine from 101 vape and they have promised to send me one as soon as tobeco sends them one. Together they look very nice and for the time being i'm using a silver plated pin from a FT king clone mod, so far so good.
All you need to do is use the Pin from the King clone head or a suitable brass screw and you are in business. 
Last edited:
How do you like your Aqua? I got mine yesterday, took it apart – looked clean. I filled it up and tried vaping – tasted like burnt machine oil. I degreased it, washed it, re-wicked and re-coiled it. I used 10 wraps on each coil of 0.6mm X 0.1mm Temco A-1 Kanthal Ribbon, approximately like 30 GA. Wrapped it on 2mm Ekowool very close together, kind like a micro coil. It came out to be 1.0 Ohm. Too low for Provari and too high for Mechanical Mod. It works, but I find that my Kayfun is much better on vapor production and flavor. But, then again, I’ve had my Kayfuns for a while now. I know exactly how to build it to my liking. And this was my first experiment with Aqua…
- Status
Similar threads
