Ended Win again! 100 x Movkin Luggy VT60W & 100 Mini's up for grabs!
- Thread starter low_tar_neil
- Start date
- th_trl_thread_readers 0
- Status
I think its strange that the last few of us who have not received ours tracking says the same thing. I hope it starts moving soon or gets found if its lost
I got a new reply, she will look into it for us. I will let you know if I hear anything new.I think its strange that the last few of us who have not received ours tracking says the same thing. I hope it starts moving soon or gets found if its lost
hello,
i will contcat forwarder, tell you specific tracking information
You should post that in the General Forum...........Your turn
I already did my Email.......and included a Note that ALL FAA Investigations of Lithium batteries incidents were due to On-board INSTALLED Lithium batteries in Use for the AirCraft - <See Boeing 787>
* I Hate how a Congressman is Spinning the Loss of a Malaysian Flight, Likely Pilot Hijacked, on a Cargo of Lithium batteries possibly catching the aircraft on fire. Yea, then it flew almost to Australia, Not its intended Destination
Everyone Needs to Respond to this Bill. The Congressman is Known advocate to BANNING E-cigarettes...................and likely in someones pocket.
You should post that in the General Forum...........Your turn
OK, done
Is anyone else finding that their Luggy tank gets really hot? I'm using the RBA with the included coil, checks in at .57 ohms. Compared to my Subtank Mini (also using the RBA and the included coil, which reads only .06 off from the luggy at .63 ohms), the Luggy has less "punch" (vapor and throat hit) at the same settings, and gets a lot hotter than the STM. I feel like a lot of the watts are being wasted, somehow heating up the tank instead of making vapor. Is it just me?
May be a new thread is needed for discussing the Luggy tank and mod since there is much to discuss but perhaps this isn't the place since they are prizes and came to us free..if you know what i mean. Some folks may buy the kit and come here to see what us early adopters have to say.
@ufosnowcat started a thread but there isn't much going on there because it is in the >E-Cigarette Product Reviews forum subsection.
You are correct though, the tank and rda section get really hot. I built a 0.9 coil and it still needs 35 watts and fully open airflow or the gurgling commences-still playing with it though!
Likely slight difference in Calculations resulting in lower wattage delivered than read on display.
Causing longer draws and subsequently increased heat.
Try bumping the watts slightly to see if performance is corrected.
I have seen this on other mods when the chip is not reading exactly what is displayed, possibly due to assembly variables.(soldering/etc.)
Last edited:
LOL, we are all getting the same reply, just wait, no tracking with USPS. Still no sign of them hitting customs at all.
Better make more popcorn and set up some beverages, it seems this might go on forever.
This should get us started
Yea, all 3 of us got the same exact reply...lolLOL, we are all getting the same reply, just wait, no tracking with USPS. Still no sign of them hitting customs at all.
Better make more popcorn and set up some beverages, it seems this might go on forever.
I should've known this would call for bacon!
- Status
Similar threads
- Locked
- Locked
- Locked
