Wismec Rx200

[Dannyson]

This happened ytd when i was trying to rebuild my bellus. After building my coil, i tried to fire it but it says
"Atomizer Short" i've tried reposition my coil and there is no visible signs that my coil is touching the base.
So, i removed my bellus and fire it on my ipv D2, it works and the coil starts to glow.
Now, when i attached the bellus back to my RX200 it fires normally.

Anybody knows what might be the cause here?

 

[Karstine]

loose post screw, 510 atty screw not touching 510 connection on mod. D2 can surprising fire a lot of atty as the 510 connection quite long. I managed to fire my goblin mini without the 510 screw on the d2 man. HAHAHA

 

[Dannyson]

loose post screw, 510 atty screw not touching 510 connection on mod. D2 can surprising fire a lot of atty as the 510 connection quite long. I managed to fire my goblin mini without the 510 screw on the d2 man. HAHAHA

Firing without 510 screw . I just find it weird that i can only fire it on Rx200 only upon dry burning of the coil on my D2

 

[Karstine]

trust me, I was such a noob back then haha. Are you vaping on a lot of malaysian juice? How long did you keep your kanthal wire?

 

[Dannyson]

Haha yes, just about a mth or so. Btw, it will only happened on newly built coil.. need D2 to fire it to *Kick start* before i can use on rx200

 

[Karstine]

either your kanthal wire is not kept properly and there's some oxide forming or you have too much gunk in the post of atty HAHA. In the future, wipe off wire with alcohol wipe and rinse with water before coiling

 

[Fruitylicious]

What happens if your d2 gg..

 

[CAPSNOSPACE]

might mean that the 510 didn't have good contact

the re-seat of the bellus to the ipvd2 back to the rx200 might be what solved the problem

 

[isux]

Because your Bellus is faithful to d2, don't poke other mods with its 510 connector.

Sent from vapour clouds above

 

[Colourless]

any issues with your rx200?

 

[Dannyson]

So far no issue.. just find it that 17 watts on d2 and 17 watts on rx200 seems way different. When firing can feel that Rx200 slowly increasing the to 17 watts whereas d2 is 17 watts straight

 

[Ninthsine]

So far no issue.. just find it that 17 watts on d2 and 17 watts on rx200 seems way different. When firing can feel that Rx200 slowly increasing the to 17 watts whereas d2 is 17 watts straight

Prolly bcos d2 does not have a step down feature whereas the rx200 has. And most likely the d2 isnt giving you 17 watts but more. Depending on how many ohms youre firing at