Wobbly 510 cuboid

[Dusif]

So i have a cuboid mod (for once an original mod) and after about a month of use i noticed the atty was a bit wobbly... I thought that the cheap mini rda (from ft) had bad threads like the previous two i had... So i ordered a new atty.. Shortly after i found out it wasnt my atty it was the 510 connection in the mod... Now its really wobbly to the point where a steady ohm reading is not an option.
Does anyone know how to fix this without cracking open the mod?

Sendt fra min D6603 med Tapatalk

 

[ian91]

You could try some of these. I use them on attys that are too long on both my VTC Mini and Cuboid.

$7.39 Replacement POM Heat Insulation Gasket for Atomizers (10-Pack) 10-pack - black at FastTech - Worldwide Free Shipping

 

[ian91]

These are from a US vendor.

KP Mod Guard - 5 Pack

 

[puffon]

You could try some of these. I use them on attys that are too long on both my VTC Mini and Cuboid.

$7.39 Replacement POM Heat Insulation Gasket for Atomizers (10-Pack) 10-pack - black at FastTech - Worldwide Free Shipping

or if you are cheap, like me.....make them out of water bottle caps....

 

[Dusif]

Thanks for the aswers, unfortunately its the 510 connector that has come lose... I can pull it up and down and wobble it from side to side... Cant spin it around tho... Seems theres no other choice than pulling the mod apart and trying to tighten the 510... Maybe put in a new one... Does any of you know anything about the fat daddy 510?... Is it any good?

Sendt fra min D6603 med Tapatalk

 

[ilovetigers100]

same question which fat daddy v3 , v4 or compatible to change loose 510 thanks