Wow - 18650 and a 510 atomizer

[SSRob]

OK so I got the urge today to damage something so I took the Dremel tool to my GGTS and reemed the inside out so my 18650's would fit in it.

Cleaned it all up and re-assembled it, 18650 dropped right in, screwed on a 510 atomizer.

HOLY SHIZA! This is like smoking 6v on a 901! I know a lot of it has to do with the 510 being a low resistance atomizer to begin with, but I'm still surprised.

 

[tparganos]

OK so I got the urge today to damage something so I took the Dremel tool to my GGTS and reemed the inside out so my 18650's would fit in it.

Cleaned it all up and re-assembled it, 18650 dropped right in, screwed on a 510 atomizer.

HOLY SHIZA! This is like smoking 6v on a 901! I know a lot of it has to do with the 510 being a low resistance atomizer to begin with, but I'm still surprised.

I don't know why you had to take a tool to it because the tenergy 18650 fit fine. I always use the 18650 and a 510 no other way to go. Imeo we are waiting for the fix for the leakage. Seems to only happen with the 510 because the pin in the middle has to be out all the way on this. Hurry please.

 

[Stormynights]

My daughter was having a bad leaking problem with her GG Storm. I looked at it and she had a 901 adapter on an 801 adapter with her 801 atomizer. I took all that off and she was amazed that the leaking stopped. The girl is blond.

 

[SSRob]

Tina,

Not all 18650's are made within reasonable spec. If you measure many of them they are 18.4~6mm wide. My 3000mAh ones are too big. Even my Tenergy ones that I bought for another device do not fit.

 

[raqball]

My daughter was having a bad leaking problem with her GG Storm. I looked at it and she had a 901 adapter on an 801 adapter with her 801 atomizer. I took all that off and she was amazed that the leaking stopped. The girl is blond.

Hehehehe... Now that's funny!

Kris

 

[tparganos]

Tina,

Not all 18650's are made within reasonable spec. If you measure many of them they are 18.4~6mm wide. My 3000mAh ones are too big. Even my Tenergy ones that I bought for another device do not fit.

Maybe Imeo needs to make the middle part a smidge bigger so they will fit better.

 

[emonty]

good tip Rob, I have loads of cheap 510's around and those 18650 batties get used this way!! Tried it: it's quite nice and like you say: much like a 901 on 6V.
Difficult thought to lay down my i7 running on 7.4V

 

[imeothanasis]

I don't know why you had to take a tool to it because the tenergy 18650 fit fine. I always use the 18650 and a 510 no other way to go. Imeo we are waiting for the fix for the leakage. Seems to only happen with the 510 because the pin in the middle has to be out all the way on this. Hurry please.

It will be ready on Saturday and I ship on Monday or tuesday sweety

 

[imeothanasis]

My daughter was having a bad leaking problem with her GG Storm. I looked at it and she had a 901 adapter on an 801 adapter with her 801 atomizer. I took all that off and she was amazed that the leaking stopped. The girl is blond.

you are more than funny Stormy, I am on floor laughing

 

[emonty]

yeah Stormy very funny!! My youngest son is also blond and when we were at the Zoo he looked at a Lama and said: that is a hot animal...Were my oldest son said: no that is Lava!

 

[Stormynights]

yeah Stormy very funny!! My youngest son is also blond and when we were at the Zoo he looked at a Lama and said: that is a hot animal...Were my oldest son said: no that is Lava!

How funny. I am glad they didn't get spit on.8-o How old are you children?

 

[Mactavish]

OK so I got the urge today to damage something so I took the Dremel tool to my GGTS and reemed the inside out so my 18650's would fit in it.

Cleaned it all up and re-assembled it, 18650 dropped right in, screwed on a 510 atomizer.

HOLY SHIZA! This is like smoking 6v on a 901! I know a lot of it has to do with the 510 being a low resistance atomizer to begin with, but I'm still surprised.

Wouldn't the effect be the same on the smaller 3.7 volt batteries I switched to, from the 18650, other then shorter battery time? I assume you are saying the 510 is the real difference, correct?

After 6 volt with Cartomizers, the 510 has been my next choice, over the 810 and 910, still learning, but the last two require constant filling of the cart, might as well drip in my opinion though I don't want to do that either, so my refillable cartos are my first choice until the AFS-2 comes out, hopefully that will make vaping less about constant attention of cart juice levels.

 

[SSRob]

I've been so set on using the GG with cartos for the last couple months that I guess I lost sight of how nice the 510 works at 3.7v. But amazingly I'm still using a 510 at 3.7v on the GGTS this evening and still digging it. I'll switch around again shortly I'm sure.

 

[emonty]

How funny. I am glad they didn't get spit on.8-o How old are you children?

7 and 9, still very young...

 

[T-Hefner]

I've been so set on using the GG with cartos for the last couple months that I guess I lost sight of how nice the 510 works at 3.7v. But amazingly I'm still using a 510 at 3.7v on the GGTS this evening and still digging it. I'll switch around again shortly I'm sure.

Yeah, If I'm doing 3.7volts it is usually a 510 I am using.....High Voltage I go with a 801 (BE112 or JOye302) Seems to have the most flavor and smoke at high volts. I also like my AFS


-Tim

 

[Lisaf01]

yeah Stormy very funny!! My youngest son is also blond and when we were at the Zoo he looked at a Lama and said: that is a hot animal...Were my oldest son said: no that is Lava!

Classic! I love it!

I've been so set on using the GG with cartos for the last couple months that I guess I lost sight of how nice the 510 works at 3.7v. But amazingly I'm still using a 510 at 3.7v on the GGTS this evening and still digging it. I'll switch around again shortly I'm sure.

Hey Rob, have you tried the new i3 AFS atty at 3.7V in the AFS?
I've found it's a lot nicer than the standard 901 due to the lower resistance it offers - much like a standard 510.

 

[clyde2801]

I got mine last wednesday, and threw a 18650 (fit fine, btw) and my last remaining 510, and have been contentedly puffing on it ever since. Tried the 6v imeoatty with 2 cr 123's, and switched back to 3.7v. The 6v setup was all right (the imoeatty is a lot quieter than any other 901 I've ever used) but I'm good with my current setup.

At least, until the afs arrives. I'll have to try it at 3.7 as well for long term, hassle free vaping.

 

[Debbie]

My daughter was having a bad leaking problem with her GG Storm. I looked at it and she had a 901 adapter on an 801 adapter with her 801 atomizer. I took all that off and she was amazed that the leaking stopped. The girl is blond.

Thanks for the laugh. My daughter is blond and I'm always teasing her. I've suggested her IQ could go up by 30 points with a brunette dye job.

Debbie

 

[Stormynights]

Thanks for the laugh. My daughter is blond and I'm always teasing her. I've suggested her IQ could go up by 30 points with a brunette dye job.

Debbie

I was blond but now I am grey. I do feel a little wiser.

 

[Bigbuyer]

@Rob

My GGTS fits the 18650 battery. I put a 510 atty on it and wow...
Huge vapor. Great idea.