Just a quick question for anyone that has experience with them. I've seen videos on how to clean them and it seems simple enough, as well as the dry burn. fill with warm water, agitate, rinse repeat. That's all fine. My only question is does anyone have any experience with old juice flavor remaining in the wicks? I'm hoping that just that simple cleaning method would remove any flavor out of the tank.
X2 Clearos
- Thread starter NeoLogic
- Start date
- th_trl_thread_readers 0
- Status
Thanks for the reply. I only have 2 clearos and both are starting to get a funky taste. Looking forward to cleaning one out tonight. How long did you wait before you used it again? Was there a long drying period?
I have three and cleaned them all at the same time. It was probably more than 12 hours but less than 24 before I used them again. The first few draws may be a little weird, but afterward it will be fine.
To speed the drying process, after 6-8 hours of air drying, I've used a combo of heating the element with a manual battery (to vaporize the water) followed by blowing air in with a blow dryer. Repeat as necessary, without overheating anything. The moisture in the wicks will condense on the sides of the clearo, and the blow dryer will dry that....DO NOT OVER HEAT, as you can ruin the seals and the wicks.
after mine drip dry.. I stand them on my pc tower vents.. low velocity blow dry 
my T3 coils go there too
my T3 coils go there tooThanks for the replies everyone, will definitely use your tips.
Also constructed a drying box for my cartomizers that I built, might release plans for it soon
Might be able to retrofit it for clearos.
Also constructed a drying box for my cartomizers that I built, might release plans for it soon
Might be able to retrofit it for clearos.
- Status
Similar threads
