XL 510 CE2 Edition 2 Clear Cartomizer Review

[Bella Chic]

Ok guys, here we go. If you have been wondering about these or on the fence about them here is a video review for you Enjoy!

Note: UGH! I cannot believe it...My external mic was supposed to be the mic I was using but my stupid internal mic was one GRRRRRRRRRR, I'm so so sorry guys, that just ticks me off and I know it's so annoying. Perhaps I will do another one and throw this one in the trash can! UGH!

 

[Guitrman1]

+1 awesome review. Thx for taking the time to put this up.

 

[Bella Chic]

You are most welcome Guitrman Thank you for taking your time to watch it.

 

[foggy1]

I enjoyed the video too...got to get me one of those

 

[Bella Chic]

Thanks Foggy and yes you should

 

[benjayman2]

Good vid Bella. I'm very surprised that you didn't get that infamous bad taste that everyone seems to get on CE2s and r2 version to boot. Well good for you If you do get the taste it is probably the primer/antibacterial stuff on the wicks. If you are worried about vaping any of that antibacterial stuff they put on the wicks disassemble the carto, burn the wicks until they are nice and shiny white with a butane torch (I have a lighter like that, which I use), soak in pga for 2 mins, and the fully dry them however you want. Sorry I always do this because one I don't like the taste of vaping that, 2 vaping antibacterial stuff sounds dangerous to me, and the only time I use cartos are for tank mods. I'm glad you haven't had any problems though. Keep on making those vids

 

[honuhart]

Thanks for that video bella, i've been wondering about those. I've never had any luck with cartomizers, they make me cough or they have that horrid burnt taste. I think i will give these a try...btw i like your videos, you explain everything in so much detail that i actually understand it the first time lol

 

[otrpu]

Loose the ballcap, bill creates cast shadows. Other than that, a great video. JMHO

Cheers,
otrpu

 

[jcleaver]

Thanks for the review. Just a quick question. In the video, you mention to put the smaller ring back in exactly like it was, and then you say to put the rounded edge down. On my clearomizers, the flat side has been the one that was down. Which way should I put it?

 

[Godzilla]

Thanks for the review. Just a quick question. In the video, you mention to put the smaller ring back in exactly like it was, and then you say to put the rounded edge down. On my clearomizers, the flat side has been the one that was down. Which way should I put it?

Same here. do you have any problem with leaking if it is stored horizontally when you leave the bottom seal out?