Your device preferences...

[down-south-vaper]

I recently bought a MVP Pro - I Sub G starter kit and I love it but at the same time I kinda miss having my ego setup (the battery went bad and all the clearmizers I had burnt up) especially for the mouth to lung hits. I really enjoy the sub ohm clounds but at the same time the complete lack of being stealthy can be problematic. Do you guys have a preference for either or still have both kinds. Also do you have opinions on what the best ego style batteries and clearomizers are nowadays. I was using the same battery and MT3 for about a year and a half before it significantly lost its output and I would usualy just get a pack of coils for the mt3. Im gonna get another setup like this and would appreciate any input from you guys .

 

[Baditude]

I've been vaping for over 3 years. For the last year I've used primarily just two setups:

A Kayfun Lite Plus rebuildable tank on a Provari (regulated mod)

A Patriot rebuildable drip atomizer on an Altsmoke Silver Bullet (mechanical mod)

On the rare occasions when I stealth vape, I use a small mechanical Smoktech Gripper. It uses an 18350 battery and 45mm cartomizer. You can also use it with a tank with the optional extender.

Gripper with cartomizer

Gripper with cartotank
​

If you're gonna stick with Ego batteries and clearomizers, I'd recommend a Vision Spinner variable voltage battery and a mini Nautilus clearomizer.

A Good Starter Setup for a Beginner Vaper

 

[roxynoodle]

An istick 30W might be even stealthier than a Vision Spinner.

 

[jeaminkim]

^ istick 30 or kangertech RED/BLACK is HOT

 

[Hans Wermhat]

I like the Kayfun for an all day puffer. I have 2 and I keep a different flavor in each so I don't burn out on one. I also keep a plume veil and a CLT 2+ on my desk next to the kayfuns and pop them on my mods periodically when I start to see the other side of the room through the vape fog. You can't beet a kayfun for flavor, but drippers give you the satisfaction of a cloud when you need it. If you want to stick with clearomizers, I suggest the Aspire brand with bdc coils. They have more cotton in them and give bigger hits and last longer.

 

[jseah]

After going into the subohm realm, I haven't looked back. Every tank that I regularly use are all subohm tanks.

 

[NealBJr]

I like a cloupor mini and a subtank nano. lower the wattage to 15W, and you can stealth vape without a hitch.

One time I stealth vaped in a movie theatre... pulled out my cloupor/subtank, put a straw in the drip tip,and it fit perfectly. Put the cloupor below so nobody can see, and all they see is you sucking on a straw.

 

[dom qp]

Clouds - Sigelei 150W + Atlantis V2 (0.3)
Flavour - Sigelei 150W + Subtank (0.5)
Semi-Stealth - Sigelei 150W + Nautilus Mini (1.8)

Obligatory stealth vape attempt on a Subtank (earlier today):

For non-sub ohm I would recommend a Nautilus Mini (1.8) on any eGo style mod that can reach up to 4.8V.

 

[dhood]

I have 6 Kayfun Lites, 2 Kayfun v4s and 3 Subtank minis. I like them all and they all have a different flavor juice in them. I run the Kayfuns around 14.5 watts and the Subtanks around 18.

 

[AndriaD]

I use 2 or 3 different Kayfuns thru the day, though I just got an Achilles RDA that I truly, truly love, and I foresee acquiring more of those ASAP. For tasting, I always use my Magma; flavor is good and true and i can close down the airflow pretty well for mouth-to-lung hits, so it makes a good taster.

I've got 2 iStick30w's, a CoolFire IV (40w); I still have a Sigelei Zmax that would be my go-to if none of the boxes were charged, though that rarely happens; usually I use the Sigelei for a "utility" mod, for dry-burning, re-wicking, initial dry-burn on a new coil, and suchlike maintenance type activities. I've got 2 mechs, a Fallen Angel (EA Mod clone), and a Galileo, both with Kicks, but those are primarily my Vapocalypse insurance. Still have 3 iTaste vv3's which all work, but I find them annoying because the battery post gets pushed down and has to be popped back up, everytime you want to use one of them, so mostly I don't. And I still have an ARO Winder 900mAh, a purty red one, and I guess it still works, but I've grown very very leery of ego-type chargers, they're so prone to FUBAR in really nasty fiery ways. So I don't use it. Oh! and I have a Vamo v2 which I've been using daily, though not for my main ADV, but it may either be retired soon or take a little rest. I need to get the gold kayfun atop it cleaned up to host a different flavor, which is still steeping.

Andria

 

[Thrasher]

Cant stand these subohm clearomizers. I think they were invented by the juice companies lol

For subohm i do a dripper on a mech.

Rest of the time for day to day a kayfun on a poldiac

 

[smacksy]

Cant stand these subohm clearomizers. I think they were invented by the juice companies lol

For subohm i do a dripper on a mech.

Rest of the time for day to day a kayfun on a poldiac

That's funny! Because if I drip I use up alot more juice than I ever do using my subtanks ..I love my sub ohm tanks...good clouds without messy dripping.. Even have the .2 ohm Arctic mounted on my BFM/XXIX mechs.. They vape great!
But it's whatever floats your boat I reckon, lol

sent from my XT1080 via Tapatalk

 

[Vaslovik]

My device preferences? Well I'm an odd-duck outsider using a mech and an RSST built as the genny it is at .7 ohm. I've settled into that, gotten very comfortable with it, and I'm not the least tempted to try anything else.

 

[SleeZy]

Been in love with my nemesis and kayfuns since i bought them.(1yr ago) They're my go out and about devices.

 

[Cowboy192]

My all day set up is a sigelei 30w mini with a lemo (I have four with different flavours in my case) built to 1ohm with nichrome running at 22.5w,
I also have a ipv3 with a Kayfun v3 sat around normally loaded with gcd
And for a easy to grab/slightly more stealth set up I have an I stick with nautilus although at the moment all 7nautilus's are cleaned and sat in a drawer

 

[TFL!]

For stealth vaping I use a ProVari P3 in 18350 mode

 

[Hans Wermhat]

built to 1ohm with nichrome

??? How do you do that??? What gauge wire are you using?

 

[Cowboy192]

??? How do you do that??? What gauge wire are you using?

Nichrome80 26awg 8wraps with a 3.5mm internal diameter loads of flavour plenty of vapour and wicks really nicely even with 75/25vg/pg

 

[DaveSignal]

I have a preference for mechanical mods. I have lots of them.

 

[Hans Wermhat]

I didn't realize there was that much room in a lemo to build a coil that big. I have a couple of Kayfun clones, but no way I could get anything that big under the chimney. I tried a 3mm 6 wrap with 28G kanthal and it arced out to the cap. It didn't actually touch, but was close enough it did arc.