Zenith V2 Clone come with Allen key grub screws or regular screws?

[Myah_June2014]

Did your Zenith V2 clone come with the Allen key screws or regular screws? Not sure if the clones in general come w/ regular screws or depends on where u buy it? Mine came with regular screws & they don't connect well.

 

[MattyTny]

I purchased a zenith v2 clone from 101vape. It's a tobecco clone. It came with allen screws, an extra set of Allen screws, two spare orings, an allen wrench, wick and wire. The top cap was extremely tight, even after lubricating the orings the top cap tore them apart. I took both off and only put one of the spare orings on. Fits nice and snug.

 

[Myah_June2014]

I purchased a zenith v2 clone from 101vape. It's a tobecco clone. It came with allen screws, an extra set of Allen screws, two spare orings, an allen wrench, wick and wire. The top cap was extremely tight, even after lubricating the orings the top cap tore them apart. I took both off and only put one of the spare orings on. Fits nice and snug.

How do u like it? I heard it gets really messy with juice since the cap is so tight & you have to drip through the drip tip or top of atty. Do u drip through top or can u take top cap off to drip right on the coils?

 

[Bapor]

I got a clone from 101vape and I have the authentic and they both came with hex screws. The o-rings on my clone came with were a little wider diameter than I think they should've been. I swapped my authentic rings with the clone and the fit was very identical to my authentic.

 

[MattyTny]

How do u like it? I heard it gets really messy with juice since the cap is so tight & you have to drip through the drip tip or top of atty. Do u drip through top or can u take top cap off to drip right on the coils?

Once you break it in a bit the airflow ring rotates with less resistance, so does the top cap itself. It's a tight fit, once I removed the orings and just put one on it was easier to take on and off. Just make sure they are lubricated.