Zfm kr808?

[Garblesnarf]

Does anyone have a link for a Zero Fill mod using the KR808 Cartimizers?

I'm new to this section of the forums and it looks like it's all for 501s.

I'll keep looking, but it someone could point me in the right direction.


...also, what's the best filler material going around these days and where is it purchasable?

Thanks!

 

[bornagainst]

There is no ZFM for Kr808.

Kr808 are disposable cartomizers, with the atomizer and filling already in place in each cartridge.

 

[SCOTTYBALLS]

You can refill your cartomizers ...

 

[Garblesnarf]

Oh yea, Born and I know well about the condom refill method. I don't know why he posted like that. I've seen him around the refill threads.

I'm just trying to find a way to do it without filler or by replacing the filler (in case I burn it).

 

[Grimtooth]

The inside of a KR8 cart, is a little different than what everyone else here usually mods... if you break a few you will see the following inside:

Approx 3" length of polyfill "Rolled" around the atomizer "core"

the "core" is a small tube or straw, maybe 1/16" of fibrous material.

there is an extremely thin wire that goes from the positive atty terminal, through the inside of the core.

When that wire gets to the end of the tube it takes a U-turn and goes back down the outside of the tube, at the halfway point it does a few quick coils around the core "straw" before continuing on to be soldered into the negative terminal of atty end. (wire has moderate resistance and creates heat when load is applied... making your juice turn to vapor)

what that means is that you cannot pull the atty core out without breaking the connection... and it is extremely hard to pull the polyfill out without doing the same, however i would say its not impossible to do so.


I am currently working out a way to use KR8 carts in a mod, but it involves cutting the outer casing off with a dremel hehe.

Grim

 

[timothy]

grim a copper tube cutter works well to cut the outer housing nice clean cut

 

[Rocketman]

They sort of look like this?