so i just got my Zmax v2 in the mail today... it was vaping like a pro today at work. when i got home and fired it up i got this error code 0.0o displaying!
tried 4 different tanks and they all work flawlessly on my lambo but it doesnt fire at all on the Zmax!
Just found one that error code is not listed. Sounds as though you may have gotten a dud.
Well mad vapes has the wrong manual for download. They have the one for the first revision. So ather may be a code for that.
Sounds like the connector pin is pushed down and not touching the bottom of the tank to make connection. I had a different mod do the same thing with the same 0.0 code
changed batteries a few times...
ya i think its the connector pin, it will fire if it is really loose but if the angle tips too far it loses connection and doesnt fire at all...
the vendor told me that smoktech said it is a short occurring...
Check the positive post on the board. There are a few weak points on the board and if you're using the standard end cap, it puts a lot of pressure on the board.
I use the extended cap with both 18650s and 18350s
Darn it! Send it back it should work more than a day! I wouldn't mess with it if you get it to work and the problem gets worse over time your just out when the guarantee runs out.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.