Zmax mini help

[nemoishouse]

Ok guys I apologize if this is in the wrong area but I've been having some issues with my Zmax. It seems nothing will fire on it. It reads the resistance at 0.00 ohms for everything. I've cleaned it with isopropyl a few times with no change. Sometimes I use a ego/510 adapter and use a T-3 on it and it might fire but that's a rarity. I kinda don't use it very often since I've been dripping quite a bit lately or using a kayfun on a mechanical but I'd like to figure out the problem to use it. The builds are usually anywhere from 1.8 to 1.0 ohms on the atomizers I have tried to use on it. HEEEEELP!!!


Nemo

 

[Sthur]

Check this post out with a solution part of the way down. Circuit board might need adjusting.

http://www.e-cigarette-forum.com/fo...es/434753-vmax-button-connection-problem.html

 

[nemoishouse]

Check this post out with a solution part of the way down. Circuit board might need adjusting.

http://www.e-cigarette-forum.com/fo...es/434753-vmax-button-connection-problem.html

Thanks!! Was beginning to think I wouldn't get a response lol


Nemo

 

[JeremyR]

It won't fire below 1.4, sounds like your not getting contact to the positive center post.

 

[Dave_in_OK]

With it reading 0.0 ohms sounds like you have a short I would check to see if anything is touching the center post from the 510 threads (shorting the two together)