zmax pressfit

[edyle]

Well after over a year of service my zmax has died on me, as I expected it eventually would.
Should be center pin insulator problem; always had a 'low load' error if I tightened down to hard.
(It wouldn't have lasted so long if I kept changing stuff on top I'm sure; I kept an adapter connected to it to let the adapter get the wear and tear).

Anyhow, surprisingly, the top came off a lot easier than I expected!

As usual, using the right kind of tools makes all the difference.

Didn't even bust the wires (so far).

 

[PaulBHC]

Lots of how to and pics in the sigelei Zmax owners thread.

I recently starting using mine part time with stacked 18350s. Thinking about someday using the board to make a 18490 box mod. dna and YiHi chips have 4.2 volt max. This one will do the 8.4 in and up to 24w out in VV mode.

 

[edyle]

Lots of how to and pics in the Sigelei Zmax owners thread.

I recently starting using mine part time with stacked 18350s. Thinking about someday using the board to make a 18490 box mod. DNA and YiHi chips have 4.2 volt max. This one will do the 8.4 in and up to 24w out in VV mode.

That's this one right?
http://www.e-cigarette-forum.com/fo...igelei-zmax-v3-v5-telescopic-users-group.html





{with the.........ahem.............. 4000+ posts}

 

[PaulBHC]

Yes that's the one. I'll poke around when I get some time and see what I can link for you.

 

[PaulBHC]

yzer disassembly pics

http://www.e-cigarette-forum.com/fo...-telescopic-users-group-321.html#post13989433

and the next couple of pages

Links to fairmana youtube videos

http://www.e-cigarette-forum.com/fo...-telescopic-users-group-324.html#post14009644