Got my zmav v5 today.. LOVE IT. but it wonk work with my kanger pro or pro2, but my T3's work just fine.. I went to a b&m store and tried 510 adaptor to see if it would help but no. any suggestions?
Zmax v5 and Kanger Protank 1 and 2 issues, no load
- Thread starter Hoofhearted62
- Start date
- th_trl_thread_readers 0
- Status
I think ive seen 4-5 posts per day about this same exact thing just on different mods. Always the same cause. You overtightened. In doing so you compressed the rubber insert sitting between the contact point and the leads from your coil, to the point that it has recessed into the base.
I had an old rubber insert lying around, cut it down and used it a as an extension to the one already there. That works as long as you make sure everything is making proper contact and avoid super overtightening it.
I had an old rubber insert lying around, cut it down and used it a as an extension to the one already there. That works as long as you make sure everything is making proper contact and avoid super overtightening it.
Don't think I over tightened, but will give your suggestion a shot. the same tanks work just fine on ego's without any issues
you are referring to the rubber that is on the shaft inside the tank above the coils right?
The opposite is true here, I think. I had to tighten the bottom very hard before it closed all the way. I heard a soft "pop" when it finally happened. The problem is that the coil is not making contact with the battery otherwise. You can see this by going to 4.Ds and switching to the Ohm readout, which will say 9.9 until contact is made properly, then it will say around 2.0 Ohm.
- Status
Similar threads
- Locked
