Ok I used to be an AVID vaper... I even worked in a vape shop for a long time but after becoming a truck driver I had trouble finding supplies on the road and it caused me to slip... I've been smoking for about 2 years now and I made the decision to really get back in it... But all my things are...
Every time when I have 2 same toy, I will modified (or damage) one of them :) Yeah, it’s typical me :) Now I have 2 Siren V2, so let’s do it.
I love Siren V2, but I wish it has bigger air holes on AFC to choose. Most of the times I like using it as it is, a restricted MTL, but sometimes I like...
Hi,
In order to understand what is going on in this video, it is helpful to have watched my other air flow videos where I cover the basics of what is going on in a low presure chamber (an RDA in use). This experiment is a result of a discusion on this very forum, and I finally found the time to...
This time I have spent a little time arguing for the benefit of placing the coils at the "wrong" place, if you like those deep flavors and middle tones, dense vapor, and som spattering for sweetness. The main theme is of course the "right" place to put your coils.
This is not about features and materials, but about the air flow and coil placement in the Pulse 24 from VandyVape. With footage and stills of air flow.
This might be of general interest... :-)
The video is about air flow on different surface cylinders in an air flow chamber. My findings are observational and anecdotal, not scientific. But my hypothesis is slowly turning into a theory. Flow comes in from the right, vacuum cleaner sucks from the...
I finished this video now because the results were so interesting. I will not be able to answer or comment for some days. Sorry for that. See you on the flip side, as the Americans say :-)
Way too long video, but important stuff. The cool part starts at about 13:00 minutes in, if you know or own the Dead Rabbit allready :-)
Sorry for the cautious vaping in the end, the air holes were only half way open:-( I'm steaming full ahead now! The vapor and flavor is astonishing! Best...
... and maybe you have too?
I just made this video, because I have made a mockup RDA to show air flow and coil placement. The result was shocking, at least to me. If this sounds interesting, please watch the video. Sorry for the length, but I think the slow movie footage from the "wind tunnel"...
If I take softer but longer puffs will I consume less ejuice than I would if I take harder but shorter puffs? Also, how much of a difference does the amount of volts affect the amount of ejuice used?
I use an ego battery and have 4 air flow options, I like using 4.2V (my coil is 1.8Ohms) and...
I haven't seen much talk about this and I think it makes a difference.
For me when I have a thinner diameter drip tip, The flavor is better.
With the thinner hole the air is more constricted giving you a more intense jet of flavor on your tongue, and not constricted in a bad way, still plenty of...
I should have my 50w IPV V2 here by the end of the week and was wondering what would be the best RBA for it would be. I've more or less have only used dripping RDAs since ive been vaping. Im looking for something that has good airflow, vapor and flavor. The bigger the tank the better.
I want...
I do not know if this has been discussed before but here is what I have learned through experience and being an engineering student. Sorry but this is a long post.
If you get harsh hits from an RDA please do read this before:
-You lose hope in RDA's
-You go out and buy juice with lower...
Do I need more air flow with thicker juice or less? More or less airflow with a lower resistance build? Like where do you set it on a .8 ohm micro coil? Any clarity that you can provide would be sincerely appreciated. Thanks Vape bros and Vape broads lol keep on vapin :vapor: =]
Woohoo!
I just started using the Aerotank from Kanger. I must say this might just be the best clearo tank I have ever used. I have used almost every clearomizer available. This tank offers a powerful punch! The airflow control, the dual coils= awesome vape experience!
My past favorite clearo...
Hey all, been a while since I posted (a few years it seems like) because I discovered the Ego + CE5 Redux combo and have been in vape heaven ever since. But very recently I decided I wanted a change (that and I can't find a solid redux supplier anymore), and picked up the KangerTech T3S and have...
If you have a BT801 rebuildable atomizer you'll know that it comes with 3 holes pre-drilled into the threaded section of the housing. There is an outer piece that you thread up or down to partially block off the holes to adjust your airflow.
After fiddling with this for an hour or 2 I thought...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.