1st time diy question

[john1211]

I just made my first batch of juice and have a question on one step that I found cumbersome. My question is
My syringe won't fit into the 10 ml bottles of flavoring. I ended up pouring my flavoring into a flask then when done poring it back into the flavoring
Bottle. What am I missing? Are there syringes that will fit into 10 ml flavoring bottles?
Any help will make my mixing life easier.

Thanks

 

[odoyal63]

I normally just remove the dripper and use a blunt tip needle.

 

[B2L]

Do you have pics of the bottle and syringe?

The only way I could see this happening is not removing the dripper cap from the bottle or not using a blunt needle on the syringe.

 

[Heabob]

On the plastic dropper top bottles, I just remove the plunger from the syringe and squeeze the drops into the top.
While holding a finger on the bottom to plug it.

Or you can remove the dropper top to draw it up.

Glass bottle flavorings require drawing it up through the needle into the syringe, as they have a bigger opening.
Then I draw some water into the syringe a few times in between flavors.

 

[Hoosier]

My flavoring syringes are simple luer 1ml and will fit easily into a 4ml bottle, so 10ml bottles are a breeze

No needles or anything but the syringe marked every 0.02ml.
Sent by big fingers on a tiny phone via Tapatalk

 

[john1211]

Guess I need to buy some blunt needles. Thanks

 

[Boletus]

Guess I need to buy some blunt needles. Thanks

The needles come in different lengths, so check that if possible.

 

[Boletus]

Guess I need to buy some blunt needles. Thanks

The needles come in different lengths, so check that if possible.