510 Atomizer Spitting - not getting full hit

[Lina]

I am not sure where to post this. I do not have this problem when I use the GLV2 - but when using my provari and a 510 atty I cannot seem to get a good hit... it get juice spitting at me and just not a full smooth hit like normal. I am using the Ikenvape attomizers... I even switched to a brand new one and same problem. When I move the atty to the GLV2 I have it does not do this.

I have raised and lowered the voltage on the provari... not sure why this is happening? Any help or suggestions?

 

[v8fd3s]

try to aim for 7 watts with this formula watts = volts x volts/ohms. sounds like youre vaping too hot. anything under 6 is too low and over 8-8.5 id say is too hot. someone can correct me if im wrong.

 

[blackHelix]

try to aim for 7 watts with this formula watts = volts x volts/ohms. sounds like youre vaping too hot. anything under 6 is too low and over 8-8.5 id say is too hot. someone can correct me if im wrong.

It all depends on the atty/carto. I have my phoenix RBA at 3.0ohms. I can crank that thing all the way up to 15watts and it never get's hot or spits at me. Every device/atty/user is different. It's best to find the setting you like and stick with that.

 

[blackHelix]

Lina, what battery are you using in the GLV?