OK. While we are on the subject. Apparently there is a right and wrong way to put the cartridge on the 510 atty. My carts are not round all the way on the male end that goes into the atty. I have been aligning the cart so that it is oriented parallel to the bridge (if the is the right term for the actual resistor). If a align it perpendicular (parallel to the metal mesh over the bridge), it seems like the plastic gets too close to the resistor and it sometimes melts a little. Am I right in thinking that the cart goes in a particular way?
And finally, I had a 901 for a while and it seemed like a could vape for at least the length of time it took to smoke an analoge without have the atty overheat or really get that hot. Lately with my 510, it seems like a can't take but a few good drags without it getting hot. Of course the draw is a hard pull too. I cleaned my atty out with a hot water rinse, and the draw improved, but I still am having heat issues. Thus, I am looking for new attys to remedy the situation. When the attys were brand new, they worked like a champ, after a few weeks though (15 ml juice) they seem to fall off in performance. Any recommendations to improve the long term performance of the Joye 510 attys. I have read the various recommendations on cleaning. How often should you clean these things to get the best performace?
Thanks tons!