Hey ECF vets,
I have been having some problems getting my homemade 5v passthrough to work correctly,
Every time I fire it, it puts out very little vaper, almost none at all.
Its wired just as it should be with the red and black as positive and ground, the positive running through a horn style switch from madevapes to the center post of the atty connector and the black ground connected directly to the outer rim of the connector.
I get 5vs from the meter until i put it under load.
Then nothing......
Also Im using the ac wall adaptor from madvapes that is rated at 2 amp so i know it should have ze juice to fire fully.
I have checked all my solder joints and the atty is getting a connection, what could make it strain so mich under load?
Any ideas guys?
I have been having some problems getting my homemade 5v passthrough to work correctly,
Every time I fire it, it puts out very little vaper, almost none at all.
Its wired just as it should be with the red and black as positive and ground, the positive running through a horn style switch from madevapes to the center post of the atty connector and the black ground connected directly to the outer rim of the connector.
I get 5vs from the meter until i put it under load.
Then nothing......
Also Im using the ac wall adaptor from madvapes that is rated at 2 amp so i know it should have ze juice to fire fully.
I have checked all my solder joints and the atty is getting a connection, what could make it strain so mich under load?
Any ideas guys?
