6v on GGTS?
- Thread starter billyapd21
- Start date
- th_trl_thread_readers 0
- Status
Yep, those are the ones to use. The actual loaded voltage output will be down around 5.2-5.3, I think, but I find that is perfect for a dual coil anyway ;-)
EDIT: wigglr got in before me. Those AWs will work fine, too
EDIT: wigglr got in before me. Those AWs will work fine, too
Can I use the same charger as I use for my regular 18650 batteries?
Sent from my PG86100 using Tapatalk
Sent from my PG86100 using Tapatalk
I have a trustfire tr-001 charger. I know they will fit but will it charge them?
Sent from my PG86100 using Tapatalk
Sent from my PG86100 using Tapatalk
This will charge both 18650s and the AW's for 6V
Ultrafire WF-188 Lithium Battery Charger
Ultrafire WF-188 Lithium Battery Charger
I have to admit, it's a nice vape..
But, I would be remiss if I don't say this..
6v at 15 ohms is going to generate 24 watts. Spread across coils, very nice.. But it's a huge hit on the batteries.
Quote from an EE mentor..
"Just remember, you're ultimately asking a *lot* from your batteries.. Lots of amps.. Not that its going to be a explody problem, if you're using good, (and protected, I hope?) batts, but it may enter in to how many charge/discharge cycles you get out of the batts before they give up"
You'll need multiple sets as well. I needing to replace every three hours or so.
Yup they draw a lot of amps from the batteries so they will drain quickly...
lifepo4's are among the safest batts.. regardless of whether you use dual coils, triple coils, or 1.5, they are 500mah (even when stacked)
maybe buy 2 to try it out.. and then purchase more if you like it. personally 6v is my go-to. but i use 3.0 atties from Cisco
lifepo4's are among the safest batts.. regardless of whether you use dual coils, triple coils, or 1.5, they are 500mah (even when stacked)
maybe buy 2 to try it out.. and then purchase more if you like it. personally 6v is my go-to. but i use 3.0 atties from Cisco
Yep..
Good batteries, and keep the hand off the bottom vent, JIC.
I've got some 3.0 ohm Duals ordered and currently dripping a 3.5 atty.. I don't want to worry about the batteries.
I use the AW lifepo4 3.2v batts stacked in a GGTB with a 3.0 306 atty in the DCA and its just perfect!
I personally think if I was going to invest in more battery's and charger I would go 5v. 6v is great but burns up cartos fast. I use both every day but about 65% of my vaping is done at 5v. Both are way better then 3.7 imho
I tried 6 volts on 2x non rechargeable CR123 and liked it.
The batts seem to last about 1.5days for me. I was topping up juice really frequently. Need to get a tank for it.
Back to 3.7v till my rechargeable 3v batts comes in.
Sent from my GT-I9100 using Tapatalk
The batts seem to last about 1.5days for me. I was topping up juice really frequently. Need to get a tank for it.
Back to 3.7v till my rechargeable 3v batts comes in.
Sent from my GT-I9100 using Tapatalk
Wow what atty/carto were you using? I am LUCKY to get 2 hours with 1.5 ohm DCC's and 3 hours with 3 ohm cartos.
Just an FYI, the amperage draw for a 1.5ohm Dual Coil isn't insanely high, only about 3.8amps. Remember that dual coil cartos are actually a pair of 3ohm coils. You're looking at around 10watts a coil, which is still pretty damn good, but nowhere near 12per/24total.
Yes they are great. If I may suggest - while your at it pickup some 1.5 triple coil cartos. IMO they are even better - seem to taste better and are a bit smoother. Only thing, they don't work at 3.7 like the DC's do. So you will need to use them at 6V only. With either @ 6V - flavor, hit and vapor is much better depending on your juice. YMMV
- Status
