801 Atty Problem

[proimage1]

I have an 801 tip on my GLV - using my 801 attys - I'm not getting any power - nothing at all - the attys are good - just got them in yesterday - they work on my other POs -??? Using a 901 with an adapter - works fine - BUT, I only have 1 - 901 atty and can't risk burning it up and being high and dry - this one has me stumped ?

Any ideas or suggestions ?

Thanks

 

[nubee]

Sounds like maybe the center post of the atty isn't making contact.
You could try a staple mod or gently pull the center post of the atty out - but just a smidge as there is a wire connection and you can break it....

 

[RatRacer]

Read here to see if this helps:

http://www.e-cigarette-forum.com/fo...have-atty-works-1-device-but-not-another.html

 

[proimage1]

Read here to see if this helps:

http://www.e-cigarette-forum.com/fo...have-atty-works-1-device-but-not-another.html

Tried pulling it up a bit and centering it better - still no go ?

 

[proimage1]

Sounds like maybe the center post of the atty isn't making contact.
You could try a staple mod or gently pull the center post of the atty out - but just a smidge as there is a wire connection and you can break it....

What's the staple mod ?

 

[doots]

I have an 801 tip on my GLV - using my 801 attys - I'm not getting any power - nothing at all - the attys are good - just got them in yesterday - they work on my other POs -??? Using a 901 with an adapter - works fine - BUT, I only have 1 - 901 atty and can't risk burning it up and being high and dry - this one has me stumped ?

Any ideas or suggestions ?

Thanks

It is most likely the center post has dropped a little too far down the tube.
The adapter is probably longer is why it is working for you than the 801 itself.

I would write to Jay and ask him if he can fix it for you.

 

[mwa102464]

I have found that sometimes the threads on one pv are a smidgent bigger or smaller than others and when trying an Atty on one pv and it was on there for a while or enen ran on that pv then trying to screw it on a differnt pv it wont work sipmly because of the threads being a tad fater..!!!

 

[proimage1]

It is most likely the center post has dropped a little too far down the tube.
The adapter is probably longer is why it is working for you than the 801 itself.

I would write to Jay and ask him if he can fix it for you.

Hey Bud - I'm actually sending it in today and have him check it out - he's doing something to keep the new batteries from being so tight going in and said he'd give it a good check over while he has it - I'll mention this to him in a note when I send it in - Thanks - TH

 

[proimage1]

I have found that sometimes the threads on one pv are a smidgent bigger or smaller than others and when trying an Atty on one pv and it was on there for a while or enen ran on that pv then trying to screw it on a differnt pv it wont work sipmly because of the threads being a tad fater..!!!

That makes sense but I've tried 3 brand new attys ?