A7 Draw?

[unloaded]

I got one of the A7's because I thought I'd like the air coming through center post and being able to adjust it with center pin. The adjustable pin is nice for making contact on different mods but it doesn't seem to effect the draw like I was expecting. I think it's because of the air holes on the sides of the connection. The draw is a little airier than I like. I've been trying to think of how to tighten it up a bit and was wondering about restricting the drip tip. Has anybody tried this? Seems to me like the results would be the same no matter where the restriction is. I could block off one or both of the side holes on the connector but it seems like the drip tip would easier. Anybody done this or can tell me why it wouldn't work?

 

[Titanium]

Nope
Not possible unless you change to a different DT.
I actually thought they were pretty tight...

 

[dwcraig1]

I got one of the A7's because I thought I'd like the air coming through center post and being able to adjust it with center pin. The adjustable pin is nice for making contact on different mods but it doesn't seem to effect the draw like I was expecting. I think it's because of the air holes on the sides of the connection. The draw is a little airier than I like. I've been trying to think of how to tighten it up a bit and was wondering about restricting the drip tip. Has anybody tried this? Seems to me like the results would be the same no matter where the restriction is. I could block off one or both of the side holes on the connector but it seems like the drip tip would easier. Anybody done this or can tell me why it wouldn't work?

Put the end of a round tooth pick in one of the two holes on the side of 510 connection

 

[unloaded]

I'm thinking of running a tap in the bottom of the drip tip so I can thread a set screw into it. I'll drill different sized holes in them to change the draw. Kind of like replaceable orfices. I remove the tips to drip anyway so I'm not concerned with it bothering me there. I'll post results.

 

[seanksean]

I got one of the A7's because I thought I'd like the air coming through center post and being able to adjust it with center pin. The adjustable pin is nice for making contact on different mods but it doesn't seem to effect the draw like I was expecting. I think it's because of the air holes on the sides of the connection. The draw is a little airier than I like. I've been trying to think of how to tighten it up a bit and was wondering about restricting the drip tip. Has anybody tried this? Seems to me like the results would be the same no matter where the restriction is. I could block off one or both of the side holes on the connector but it seems like the drip tip would easier. Anybody done this or can tell me why it wouldn't work?

It was suggested to me on ukvapers that a bit of aluminium tape with a needle hole might do the trick. I've got used to the airy draw though and now prefer it.