A7 RBA Provari Error

[cryfreedom66]

Hey guys...running into a strange problem here...

I just got an A7 rebuildable and assembled and installed my first wick and coil. When using it on my provari I get a OP error...now the strange part is...if I use it on my Provari with a 510 to 510 adapter it works perfectly....anyone have a clue why this would be happening?

 

[supertrunker]

When i test the Ohms on my A7s i have to wind the centre pin down flush with the threads so the gadget i use reads them at all. I don't use a Provari - but A7's are notorious for wobbly centre pins and so after testing mine - i screw them back up again. If it works when wound down - make sure you check that pin and maybe even put a gasket around it if necessary.

Hope this helps.

T

 

[cryfreedom66]

When i test the Ohms on my A7s i have to wind the centre pin down flush with the threads so the gadget i use reads them at all. I don't use a Provari - but A7's are notorious for wobbly centre pins and so after testing mine - i screw them back up again. If it works when wound down - make sure you check that pin and maybe even put a gasket around it if necessary.

Hope this helps.

T

that did it! just had to wind it down a little and now its fine...thanks a lot!

 

[Unforeseen]

Moved to Assorted PV Topics - Rebuildable Atomizer Systems