Acouple of pics of the Beast

Status
Not open for further replies.

SLIPPY_EEL

Vaping Master
ECF Veteran
Oct 11, 2013
3,127
3,908
Ω England Ω
Finally got my mech reo yesterday, liking it a lot :D

DSCF0045.jpgDSCF0046.jpgDSCF0047.jpgDSCF0048.jpgDSCF0049.jpg


was using 26 and 28 gauge yesterday in all sort's of way's, no matter what I tried it vaped well :D
Then today I remembered I had some 0.8 ribbon so wrapped up a 6 wrap on 2mm id which came out to
0.9ohms, will be sticking with the ribbon for a while :p


also, whats the best sort of voltage to swap out batterys at? 3.7 or 3.8 or?

thanks

oh and sorry about the stupid sideways pic

and big thanks to rob, glad you sent the extra post screws cus im a bugger for
swapping out coils all the time :D
 
Last edited:

X-Puppy

Cloud Hound!
ECF Veteran
Verified Member
Sep 13, 2013
2,262
12,612
Marysville, Washington, USA
Congrat's on your beasty mech machine! :)

I found ribbon wire to be super responsive, how about you? First time I dry fired it after a fresh wrap, it drooped. Thank god for a ceramic deck. Really nice vape though.

The answer to your battery question depends on the battery. I usually swap it out when it starts to loose steam. If you run them down too much too often they don't last as long. I never run mine below 3.5V - usually around 3.8V is when I make the switch.
 

SLIPPY_EEL

Vaping Master
ECF Veteran
Oct 11, 2013
3,127
3,908
Ω England Ω
Thanks for the welcome's :)

Yeah the ribbon was working a treat, was the first time was able to use it properly, i found if you
heat & cool it 3times while its on a drill bit, pulling tension in between aswell & then take it off
the drill bit just holding the legs, heat the coil again but vslow heat building up it won't disform.

Then i tryed some 28g again, got .9 ohm's on 1.5mm id 6 wrap micro* & now we're talking! Wow i dunno
this hasnt got the crispness like ribbon but flav is richer and clouds are more dense to me :)

My fav flav's atm are Black Gold from joosejuice, fizzy trifle from trip hammer or Mango :p
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread