AGA-T Question....need Help

[AMUP0121]

I bought the AGA-T last week and have been having trouble setting it up. The peice that screws into my mod is not connected to the atomizer and I can not tighten it down on my device with out distorting the coil and wick. Can anyone tell me from these pictures if the connector is broken or if it it supposed to be this way. It was like this the day I got it and haven't had any luck setting it up.

 

[Sgresham]

you need to push it up. The screw part on the 510 connector should sit right on the bottom of the RBA, and the stem should be flush, if any of that makes sense.

 

[brian5470]

Looks like the connector popped out you need to press fit the 510 fitting back into the bottom of the tank.

 

[AMUP0121]

Yes, it does make sense, it just never gets tight when I screw it down on my mod. It wobbles and the center pin turns when I try to screw or unscrew it from my mod. I was looking at my "Griffin" RBA and the center post goes through the 510 connector, but the connector does not separate from the base of the atomizer.

 

[AMUP0121]

Looks like the connector popped out you need to press fit the 510 fitting back into the bottom of the tank.

So the 510 connector is not supposed to separate from the base?

 

[eHuman]

Just a guess, sounds like the bushing that the post presses into either has too much play or is in too deep to to grab and snugly hold the center post/510 connecter. Try removing the bushing, putting it on the post and then inserting into bottom plate. It's worth a shot.

 

[bk78]

I would contact the vender who you purchased it from and get a new one. The connection is not supposed to come off like thst

 

[Rule62]

So the 510 connector is not supposed to separate from the base?

No, it's not. The 510 connector should remain attached to the base. The center post goes up through the center tube of the tank, and is held in place with the little knurled nuts at the top.

 

[Dieseler]

To echo what above poster said
contact vendor as that 510 does not come out -its press fitted into bottom of tank.

 

[natchez]

Not sure what is up with yours. I looked at my wife's and although the center pin can come in and out, the bottom threaded piece seems firmly attached. I would try contacting the vendor. Perhaps, yours just "broke" off during handling or shipping.

 

[AMUP0121]

Alright everyone, thanks for your responses. This is what I thought was the case, I just wanted to make sure before I contacted the vendor. I appreciate your help.