AGA-t+

[Kiva]

So I've followed eHumans blog on how to rebuild the AGA and it's working amazingly. But even with all my screws in the top after vaping for a little while if I take the cap off, the deck is covered in liquid. And ideas on what's causing this?


Sent from my iPhone

 

[Crash Moses]

It's either condensation from the vapor or juice coming through a loose fitting wick or a combination of both. My bet is that it's just condensation.

 

[Flyer]

Flooding from excessive tipping?

 

[Jeremy Evans]

Mine tends to get pretty full of condensation. Its a .5 dual coil single fatty wick setup though

 

[Kiva]

I just cleaned the deck and inside of my top cap and held it upside down and no liquid comes out of the wick. Making me think that the wick is thick enough and big enough to not leak?


Sent from my iPhone

 

[Kris Bury]

combination of condensation and splatter. if you ever wet fired it with the cap off you would see it splatter and pop little hot juice droplets everywhere. Not to worry though, any excessive build up will slowly wick back into the tank, if you leave your fill screw out this happens almost instantly and you can even fill right through the drip tip or drip tip hole with the cap still on

 

[Crash Moses]

I just cleaned the deck and inside of my top cap and held it upside down and no liquid comes out of the wick. Making me think that the wick is thick enough and big enough to not leak?


Sent from my iPhone

Condensation and splatter as Kris said then. Mine will start to gurgle a bit while tilting and chain vaping. I just hold it vertical and continue to vape until the excess has been vaporized. Nature of the beast.