Anybody Using A Kabuki?
- Thread starter jwbnyc
- Start date
- th_trl_thread_readers 0
- Status
I just bought a GMZ P3 for $169 a few minutes ago. They still have GMZ classics also.
By the way, put in a ticket today asking why there were GMZ P3s in the blem section but not in general stock, and the response was that while it isn't official yet, they will likely not be offering that finish any longer.
Zen also has some GMZ styled Provaris for sale on his site...I got a GMZ mini from him not too long ago.
I'm not gonna defend them cause like I said I don't care for them.
But in there defense they have a lower (by far) DOA rate.
For vapor none of the gear gives any to speak of which is why I use it when I do. When I wanna keep it on the DL I use a Kabuki on a 2.5. When I want vapor I screw a rta on the Radius and crank it up to 30w.
For flavor everyone is gonna be different. I get zero flavor at that level. For me its nicotine injection. The Radius setup mentioned above with some tasty low nic is where I go for flavor.
I keep reading about coils getting stuck in the chimney. I can't visualize it. Maybe I don't know what the chimney is.
That's cool! Never had the pleasure of trying out a P3, a? Well, I've never had the pleasure of trying out a Radius! I plan on getting Jackie one for her birthday this summer but I'm at odds weather or not I'm getting one. If I do, it will be for the sole reason of sharing a new experience with her. Now that one of my V2's has a P3 connector, not really sure I want to spend the extra cash on myself. Plus, I REALLY like that P3. Who knows... I have some time to think about it.
Since this a Kabuki thread, I would like to add, using a Kabuki with that V2 was like holding a miracle in my hand! I loved it, absolutely loved it!
snagged oneI haven't been able to follow the thread, so I'm not sure anybody noticed this... a small batch of Gun Metal Kabukis are up on sale at ProVape
It's the top tube part. Usually the coil stays in the base piece when I unscrew mine to refill. I think after a while the coil gets a bit gunky and sticks to the top tube part. It seems harder to get the base piece screwed back on when the coil stays in the top piece, easier to cross thread the thing.
I too enjoy a good RDA, and a good RTA, such as the Aromamizer, and Bellus, But I don't understand the post saying that they don't get the flavor when using the Kabuki. Mine has a wonderful flavor.
I do wish I had some higher NIC. here for it. Think I'll just add a touch.
I tried the DYI thing, and for the life of me, I can't get the flavor I want. Spending way too much on liquid, with the wife and I both enjoying vaping so much. Our go to vape is VapeWilds On Cloud Custard. Yum!!!
Wish I could match it!
I do agree that there is less Vapor with the Kabuki, which is from time to time, a very good thing when out in public. but if I'm feeling Froggy, I still use the Aromamizer. The real plus for us, is with it having such good flavor, it uses a LOT less juice. And this helps us out a hole lot.
Love Em Both!!!
Wish I could match it!
I do wish I had some higher NIC. here for it. Think I'll just add a touch.
I tried the DYI thing, and for the life of me, I can't get the flavor I want.
Spending way too much on liquid, with the wife and I both enjoying vaping so much. Our go to vape is VapeWilds On Cloud Custard. Yum!!!Wish I could match it!I do agree that there is less Vapor with the Kabuki, which is from time to time, a very good thing when out in public. but if I'm feeling Froggy, I still use the Aromamizer. The real plus for us, is with it having such good flavor, it uses a LOT less juice. And this helps us out a hole lot.
Love Em Both!!!
Wish I could match it!
I am now kabuki'ed? Is that correct? I have one, and it's good! On par with my squapeRs, and that says a lot!! Still though, I have it mounted on my p3 altered 2.5. Because it stays in that power range. Radius is meant for more power, and it gets it. Kabuki, yes! Kabuki and radius... not so sure.
Hey all,
Mostly a lurker, but I do have a Kabuki related question. I have provari 2.5 GMZ. Thinking about a Kabuki 510 for it. Also thinking about getting a radius, which means I'm thinking about getting a kabuki P3 instead. My budget is such that I can't get both right now, but I getting my self a one year vape-a-versary gift.
So my question (finally) is:
What is it that I hear about flattop 2.5s? The 2.5s are a great deal right now, so if I could get a P3 topped 2.5, I would get that and the P3 Kabuki GMZ while they last. (Really want the radius, but that will still be there in a few months.)
Also, a more general Kabuki question for y'all: the Naut mini and the kanger SubTankmini are the tanks that got me to quit. I use the kanger (or drip) most of the time around 1.2 to 1.6 under 15w. I can almost enjoy the Naut mini, but the draw is too tight and the flavor too muted. I'm hoping the Kabuki will fall in between the two tanks (better vapor, flavor and airflow than the nautilus, have similar air to a closed up SubTank mini and maybe sip a little less juice). Is this a reasonable expectation or is the Kabuki pretty similar to a nautilus mini, but better?
Mostly a lurker, but I do have a Kabuki related question. I have provari 2.5 GMZ. Thinking about a Kabuki 510 for it. Also thinking about getting a radius, which means I'm thinking about getting a kabuki P3 instead. My budget is such that I can't get both right now, but I getting my self a one year vape-a-versary gift.
So my question (finally) is:
What is it that I hear about flattop 2.5s? The 2.5s are a great deal right now, so if I could get a P3 topped 2.5, I would get that and the P3 Kabuki GMZ while they last. (Really want the radius, but that will still be there in a few months.)
Also, a more general Kabuki question for y'all: the Naut mini and the kanger SubTankmini are the tanks that got me to quit. I use the kanger (or drip) most of the time around 1.2 to 1.6 under 15w. I can almost enjoy the Naut mini, but the draw is too tight and the flavor too muted. I'm hoping the Kabuki will fall in between the two tanks (better vapor, flavor and airflow than the nautilus, have similar air to a closed up SubTank mini and maybe sip a little less juice). Is this a reasonable expectation or is the Kabuki pretty similar to a nautilus mini, but better?
Kabuki is on a higher plain than the Nautilus - I have both the mini and full size Nautilus and the Kabuki is just better. Better in all aspects - flavor, vapor, airflow.
As to your question on the 2.5 - I believe ProVape has the Satin Silver and the Polished that you can opt for the P3 top cap for an additional $10. That is a worth buying IMHO. I have only 510 Kabukis because I have more 2.5 that I have no interest in getting P3'd and the 510 will go on other mods if you so choose.
Zen, at House of Hybrids offers the P3 top cap conversion for $45 (if I'm not mistaken)
There are also clones of the Kabuki - very well made, in fact side by side I can't tell the difference unless I look at the 510 pin - though they do not come in GMZ for obvious reasons. There is a GMZ metal tank section offered by House of Hybrids though for around $15 methinks.
If I were getting a Kabuki to dedicate to a P3 connection then sure - go for it Lots of options!
As to your question on the 2.5 - I believe ProVape has the Satin Silver and the Polished that you can opt for the P3 top cap for an additional $10. That is a worth buying IMHO. I have only 510 Kabukis because I have more 2.5 that I have no interest in getting P3'd and the 510 will go on other mods if you so choose.
Zen, at House of Hybrids offers the P3 top cap conversion for $45 (if I'm not mistaken)
There are also clones of the Kabuki - very well made, in fact side by side I can't tell the difference unless I look at the 510 pin - though they do not come in GMZ for obvious reasons. There is a GMZ metal tank section offered by House of Hybrids though for around $15 methinks.
If I were getting a Kabuki to dedicate to a P3 connection then sure - go for it
Lots of options!
Thanks. I missed that $10 option on Provape site, because I was only looking at the GMZ 2.5 where it is not an optionKabuki is on a higher plain than the Nautilus - I have both the mini and full size Nautilus and the Kabuki is just better. Better in all aspects - flavor, vapor, airflow.
As to your question on the 2.5 - I believe ProVape has the Satin Silver and the Polished that you can opt for the P3 top cap for an additional $10. That is a worth buying IMHO. I have only 510 Kabukis because I have more 2.5 that I have no interest in getting P3'd and the 510 will go on other mods if you so choose.
Zen, at House of Hybrids offers the P3 top cap conversion for $45 (if I'm not mistaken)
There are also clones of the Kabuki - very well made, in fact side by side I can't tell the difference unless I look at the 510 pin - though they do not come in GMZ for obvious reasons. There is a GMZ metal tank section offered by House of Hybrids though for around $15 methinks.
If I were getting a Kabuki to dedicate to a P3 connection then sure - go for it
They are saying that they use a higher nic level (12) and it mutes or muddles the taste of juices. I agree, I vape 18mg and I too use it just for the nic hit, not so much for flavor as the flavor is considerably different at this high of a nic level. An 18 and a 3 of the same juice is going to taste completely different.I too enjoy a good RDA, and a good RTA, such as the Aromamizer, and Bellus, But I don't understand the post saying that they don't get the flavor when using the Kabuki. Mine has a wonderful flavor.
I do wish I had some higher NIC. here for it. Think I'll just add a touch.
I tried the DYI thing, and for the life of me, I can't get the flavor I want.
I do agree that there is less Vapor with the Kabuki, which is from time to time, a very good thing when out in public. but if I'm feeling Froggy, I still use the Aromamizer. The real plus for us, is with it having such good flavor, it uses a LOT less juice. And this helps us out a hole lot.
Love Em Both!!!
Wish I could match it!
Zen can do the GMZ for you, if you get it. He's done two for me and they look awesome with the flats.
Does someone mind posting a picture of the GMZ P3 + GMZ Kabuki combo? Trying to talk myself into or out of, not sure yet. Lol.
Kat posted one not too far back. There was another too, and I think I also might have done one. Recently (within the last two weeks, for sure).
Don't look (you'll buy) .
Sorry. Ours weren't P3, but the other was. I think it was either JUMA or F2V that posted..
This is not a great picture--the GMZ is 3rd from the left. I sent it to Zen for the P3 conversion.
- Status
Similar threads
- Locked
