Anyone tried 3.7v 17670 in V2?

[New_World]

do 1800mAh 176770 protected ultrafires fit in there?

I've heard only some 176770's fit in the V2.

thanks

 

[BrockJ]

I've not tried but this one looks like it would UltraFire 17670 3.7V Li-Ion Rechargeable Battery 1800 mAh CR17670 Lithium Ion

It shows to be 17 x 67 but that varies some with asian mfg's.
At $6/ea we'll know in a few days. I just ordered 2.

I also ordered some of the 14250's to see if I could get the Protege to run @ 6v Hopefully they'll be here soon.

 

[solitary1]

I've not tried but this one looks like it would UltraFire 17670 3.7V Li-Ion Rechargeable Battery 1800 mAh CR17670 Lithium Ion

It shows to be 17 x 67 but that varies some with asian mfg's.
At $6/ea we'll know in a few days. I just ordered 2.

I also ordered some of the 14250's to see if I could get the Protege to run @ 6v Hopefully they'll be here soon.

Hope you got a copper or some other type replacement disc for your switch or it won't matter.You'll be resisting that 17670 down to unusable voltage.My protected ultrafires won't go(grey wrapper).If you have the switch adjusted you could go with the 16340 3.7v and a dummy spacer,not as much mah but it fits.

 

[unkuser]

Those batteries won't fit. I have them and the plastic wrapper is too thick.

 

[BrockJ]

I've done a 14500 with a spacer. For a copper disk I used the copper split ring off of a #8 glow plug for Nitro RC helicopters. *Friend of mine owns a Hobby shop that I run on the weekends* Works just like a large heavy Protege.

 

[buGG]

I've not tried but this one looks like it would UltraFire 17670 3.7V Li-Ion Rechargeable Battery 1800 mAh CR17670 Lithium Ion

It shows to be 17 x 67 but that varies some with asian mfg's.
At $6/ea we'll know in a few days. I just ordered 2.

I also ordered some of the 14250's to see if I could get the Protege to run @ 6v Hopefully they'll be here soon.

regarding the 14250s...did you order the protected or the unprotected? the protected ones are a tad long, they'll get in there but with the spring it's a very tight fit...i'd stick w/ the unprotected for the protege (yeah, risks and all). make sure you're using a hv atty, I use the 4.7 ohm resistance with the 14250s. i think anything less and pop goes the weasel!

hey steve, any results yet on this voltage under load?

buGG

 

[BrockJ]

didn't get the 14250's in yet but, I'll just use the ring out of the V2 in it for stepdown.

Steve's suppose to sell the rings once they get caught up. V1, V2 and Protege all use the same size.

 

[New_World]

helpful info.

keep me up to date on how it goes.

 

[unkuser]

You know what they say:

Once you go 5V you never go back.