Apollo Vtube Draw is too tight.

[Covert]

I am using a Vtube with a DCT and the Stock Cart that came with the DCT. When the tank is all the way tightened down it's almost like trying to suck a golf ball through a garden hose, but if I loosen it up a bit the draw is darn near perfect. I am worried about the wiggle room this creates though is there anything to rectify this problem?

 

[NGIB]

Saw a post on this earlier today. I believe the solution was to use a 510 to 510 adapter (extender). I keep a 510 to eGo adapter on mine as I use clearos sometimes...

 

[Kay1959]

Sounds like you might have the bottom end cap too far down on your cartomizer. The bottom of the end cap should be flush with the flat part of the cartomizer. Try scooting the bottom end cap up just a bit and see if that helps.

Or does your cartomizer have a flange? If so, then this isn't the problem. Just thought about that.

 

[panhandleguy]

Mine is the complete opposite. vey airy. Ordered the adapter/extender and am waiting on it's arrival to see if that fixes the problem

 

[Sdh]

Saw a post on this earlier today. I believe the solution was to use a 510 to 510 adapter (extender). I keep a 510 to eGo adapter on mine as I use clearos sometimes...

I suggest this as well. Try to purchase a sealed adapter. I use these on every mod I have. It also saves time when a carto or atty decides to pop. (Easy clean up.)

I am using one on a apollo v-tube right now. Good luck!

 

[Vapoor eyes er]

Yep either buy an adapter or mod the existing connector.

 

[Covert]

Kay1959 My Cart does have a flange but you were right I scooted the tank up a little bit and it is perfect now! Thank you ! : )