I got a 510 starter kit a week ago from litecigusa it came with 2 attys. After a week of using the same atty i thought it was time to switch out to the un used one to clean the other one. The new one seems to have much less throat hit and doesnt make the sizzling sound the other one made since day one. I thought it could be the cart so I switched back to the used atty and great th and it sizzles. I did blow out the oil from the new atty before use. Is it possible it is not getting hot enough? There is loads of vapor just no TH. Do attys need to break in some? thanks for any help
Are all attys the same?
- Thread starter Vaporblind
- Start date
- th_trl_thread_readers 0
- Status
"Are all attys the same? " That's a kind of a million dollar question 
IMHO, (& I'm sure others will agree) I'd say no.
Yes, some atties seem to work well from the start but others need breaking in - they can be rather fickle little beasts
IMHO, (& I'm sure others will agree) I'd say no.
Yes, some atties seem to work well from the start but others need breaking in - they can be rather fickle little beasts
You need to prime the atty too! Put 4-5 drops on the new atty before you pop on the cart
Lori
Lori
I have found that it is nearly impossible to break the wire in a 510 attie with my hands, the only way an attie(510) will break is by the solder joint.
they make them weak , or with crap solder so its a lottery : but most atties last 2 months
they make them weak , or with crap solder so its a lottery : but most atties last 2 months
I did put in a few primer drops in it. I also noticed som white material under the atty bridge poking out to te side of the bridge. I think it is wick but I have never taken one apart so I dont know if this is normal.
Go here > http://www.e-cigarette-forum.com/fo...your-510-atomizer-step-step-801-901s-too.html
and you will see an atty being taken apart and rebuilt. Page down several times and there's a closeup of the wick (silvery fiber bundle) being pulled into a new coil. It's kind of like Atty 101.
You may have flooded the atty that has no taste. Try blowing it out from the battery end and vape it again without priming.
Thanks for the link dave I see the white thing is part of the atty. WOW I don't think I will try to repair a dead atty @$7 I will just replace.
- Status
Similar threads
