Aromamizer RDTA by Steam Crave
- Thread starter roxynoodle
- Start date
- th_trl_thread_readers 0
- Status
I finally got a chance to try my hand at Clapton wire. I tried 32 on 28 but the 28 kept twisting and snapping. I ended up getting 32 on 26 to work. These things like to jump around on ohms as you fiddle with them!! Built a total of 4 coils but lost 2 of them due to snapped core wire while adjusting them. Definitely a learning curve involved. Finished a build on the 3ml Aromamizer with duals at 4 wraps, 2mm ID, 2.5 ohms. This is honestly lower than I wanted to build, but they can handle higher watts than I'm used to at 35+.
The two that died for science.
The two that died for science.
I kept having that same problem. I ended up attaching one end to a swivel and the other end to my drill. No mo snapoI finally got a chance to try my hand at Clapton wire. I tried 32 on 28 but the 28 kept twisting and snapping. I ended up getting 32 on 26 to work. These things like to jump around on ohms as you fiddle with them!! Built a total of 4 coils but lost 2 of them due to snapped core wire while adjusting them. Definitely a learning curve involved. Finished a build on the 3ml Aromamizer with duals at 4 wraps, 2mm ID, 2.5 ohms. This is honestly lower than I wanted to build, but they can handle higher watts than I'm used to at 35+.
The two that died for science.
Sent from my VS986 using Tapatalk
I made this, clamp it to the table. I think the swivel is bent, to big, or I had to much pressure on the core wire. I'd get a good 2 inches wrapped and then SNAP! Repeat until aggravated....
OMG, or you kiding me? People think the Aromamizer is hard to fill and want a top fill???
I have actually easily poured from a bottle into the well housing the little holes. Who needs a syringe, needle nose or dripper?
100% VG is very slow to fill from a bottle unless you warm it up first (which is what I do). Just run the bottle under warm water for a bit. Or use a syringe.
It can be filled normally from a bottle but takes awhile. I too would love to see top fill and a built in AFC band.
It can be filled normally from a bottle but takes awhile. I too would love to see top fill and a built in AFC band.
eats everybit as much as the tfv4 in quad mode...so yes it does or can. mines running dual microcoils 24ga 9 wraps .35 ohm 3mm ID from 70 to 80 watts ans its chugging juice.
build above is worki g great...3 post deck wicked with rayon cut 45 degrees so allz flat and fluffy on the deck.
Luckily enough my airholes line up with centered coils on the deck 2 holes seems to be the deal helps neg pressure for wicking too.love this tank
I use a 120 ml sqeze bottle with a luer lock top and a seringe needle ..allways ready
I like the bottom filling just fine . can inspect the coil and wicks when refilling.
we got such a versatile tank for experimenting with ...once you like your setup just use the vape band to set the air the way you like and replace it with metal tape and open the hole or two .easy and looks good to.
like it just the way it is!! my third one is on the way with a couple of v decks.
Has anyone noticed any discernible difference in performance/flavor between the 6ml and 3ml versions? I'm a fan of small tanks, but the 3ml seems harder to get atm. Are the sections interchangeable? If I buy the 6ml can I convert it to 3ml later?
So, I've been playing with this one for a bit...flavor and clouds have been good. Twisted up some 28ga kanthal over the weekend, and put a 6wrap/2.5mm/.44ohm dual coil in last night...AND WHOA!!!! This flavor and vapor are intense. Using 50/50 3mg....and if you chain vape too long...the nic chills set in!!!!!!
Don't know if it is anything special about that build in this tank...but whatever it is...I seem to have nailed that sucker.
Don't know if it is anything special about that build in this tank...but whatever it is...I seem to have nailed that sucker.
I just ordered a 3ml version from Steam Crave..is it being sent from China? I couldn't quite figure that out. Am I waiting like 8 weeks to get it or what?
Are you the great Zombo com? http://www.zombo.com/
And to answer your question, yes, being sent from China, but not like 8 weeks, probably more like a week and a half or two.
- Status
