Ask a PIF mod or vet

Status
Not open for further replies.

loxmythe

Resting In Peace
ECF Veteran
Jun 14, 2010
21,922
20,700
pa
Actually sounds like an ego mega cartomizer. You must take the 2 caps off the whistle tip (outer and then an inner) poke through the sealed plastic of the fill port and there's a fill tube on each side so you need to angle the needle - fill 1 side then the other side. Goodprophets used to have a fill video in their sub forum.

Note - they melt at 7.4 :blink:
 

CalamityJan

Vaping Master
ECF Veteran
Verified Member
Dec 29, 2009
9,237
41,653
TX
Question for the Mods, please?

I would like to have little PIF members contest to celebrate my 2 years of vaping. (yeah, a bit late) It would not be limited to only PIF members, of course, but I would prefer it to be listed in here rather than the general members contest section.

I have a helper, a rough idea of content, and have all the prizes gathered. What is my next step as far as formally submitting this request? Need to know if y'all want an outline, list of general rules, list of prizes, etc..

Please PM me what I should do next. Thanks bunches, I appreciate everything you do and hope this doesn't burden anyone!
 

Prism

ECF Guru
Supporting Member
ECF Veteran
Verified Member
Jun 4, 2010
14,117
21,391
Wisconsin

BiancaMontgomery

SQUIRREL!
Supporting Member
ECF Veteran
Verified Member
Jan 27, 2010
13,516
8,065
North Carolina
I bought some prefilled, sealed 'Smok Tech 1.7 ohm RN4081 cartos' I was later told will not match the NJoy Pro, so I would like to list them separately ,but would also like to know what they do match up to? TY

The ohms are too low for your skinny 4081 batts, this is why you were advised not to put them on those batteries. Not only would they drain the battery very quickly, but because the mAh rating on those batteries is low, they could basically be fried. If you had a device with 650mAh or higher you could use those cartomizers with it. There are adapters that would allow you to use them on, say, an ego type battery. (510 to rn4081 adapter)
 
Status
Not open for further replies.

Users who are viewing this thread