Atmistique Atomizers
- Thread starter billakosgr
- Start date
- th_trl_thread_readers 0
- Status
I know I'm excited to try the V2 and since I didn't have the V1 I'm sure that there will be a learning curve. I'm good at learning curves! So Like I said "I'm so excited, I just can't hide it, I'm so, I'm so, I'm so Excited". Shoot now I'll be singing that all day.
Too funny.
I stopped posting when I sold my Diver 1. Now that you guys have had some experience with the Diver 2, convince me that it is better and less fiddly the V1. The thing I hated about the Diver 1 was I couldn't seat the cup or get it back out without breaking it. Has this issue been fixed. I was about to order a truck load of cups but decided to sell the Diver 1 instead.
Good to have you back Casey! Now there's another missing... need to go hunting raqball
I install the cup so there is a tiny gap there. It won't leak, it's designed to not need to be hermetically sealed there. I am going to run a test where I break off the whole top of the cup, and just leave the bottom base with the tiny holes for the NR wire intact. I suspect the flavor will be a bit muted, but it will work just fine.
If you tried that with the v1, it would snort in derision, throw its makeup bag at you, and then call the police.
yes, this is what I do with the V2. I always take my cup out in this manner.
I have only been using the diver 2 for a few weeks now and I must say it is the simplest to set up of all my tank attys. I also find that I can just pull the cup straight out with my fingers....maybe this isn't normal or I have "hulk" fingers....little snug but removeable by fingers! I did not have the v1 but the v2 has been very friendly thus far!! No leaking, dry hits, etc.
I recently made this http://www.youtube.com/watch?v=PiWPqyO0-XE&list=UU79X16EQjPWxLE1wK_eqyDQ
with 2x2Ohm coils and the results on a mech mod was FANTASTIC....!!!!!
just try it
with 2x2Ohm coils and the results on a mech mod was FANTASTIC....!!!!!
just try it
Looks interesting, will give it a try this weekend! Thanks
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
Fantastic Wedding Rings
Is anyone using the diver v2 with a billetbox with ready wires? Was wondering was ohms are you running?
Willowize that's what I was thinking to use due to the BB lowest setting is 4v. I got my diver today but it's seems like when I assemble it and screw the top base on its seems to cut the silca wick and doesn't seem to be enough strands to soak up the juice
rbrtito, I understand that you have to make sure that the silica is in the slots on each side and be careful to keep them there while screwing top onto bass for that very reason. Plus don't cut the silica until after atty is screwed together. There are several good video's a few pages back that shows this. Hope this helps.
I plan on using 100% organic cotton balls. I like flavors better with cotton wicks.
I plan on using 100% organic cotton balls. I like flavors better with cotton wicks.
- Status
Similar threads
- Locked
