Atomizer Draw?

[Lumiis]

I know this topic is on the forum Somewhere! But I Cannot Find It!

Is there a way to stiffen the draw on an atomizer in a mod?

I've tried using the tip of a toothpick, wont fit in the hole, any suggestions?

(PS: If anyone happens to know where this has been discussed a link would be great, then delete this post)

Thanks~Zaija

 

[roadrash]

I use a carto condom, If its a pen style bat I cut a little notch (diamond shape) in the middle and slide it down over the atty-bat conection. Works good for keeping a e2 syringe mod connected to a pen style bat also. for a box mod I cut a small v out of the bottom and slide it down till it hits the box. Turn- adjust as needed.

 

[Lumiis]

I tired this, and immediately thought 'This Sucks' - Came back to it today, made some alterations and made it work!

The piece I use is maybe a millimeter wide, no notch, at the bottom of my atty, don't cover the holes with it, as you will receive no air flow at all & will burn your juices easier.

Thanks ~Zaija