atomizer hard to blow through

[cashresolution]

I don't know what to say about atties..I clog mine up and then let them set in everclear over night..and still no luck. I think we just need to start adding the cost of a couple atomizers a month to our bill maybe one day this will be worked out..

 

[BradSmith]

I am now a fan of the crest pro blue mouth wash. Just soak for 15 minutes agatating every few minutes and rinse in hot water after. If the mouthwash turns green or you see black bits in it your good to go. I have used boiling water and bacardi 151 and no luck but the mouth wash works. hope this helps.

Yep works for me. and check the airholes. If it's getting hot you can get it to work.

 

[robl45]

I have another one that clogged.. I poked the holes, and still its clogged bad. I set it in hot water, no go, I will try some cola. don't have any blue mouth wash.

 

[robl45]

just tried blue mouthwash, still clogged, in fact I have 2 out of 3 that I bought in the past week are completely clogged now. One was fine one second and clogged the next so I can't buy that its liquid in there, more like internal parts or something. does anyone have a diagram of these things or something or can explain where the vent holes actually go from top to bottom?

I did notice on one that if the wick was moved from one spot to the other that I could breathe through it easier. This is getting frustrating though. I can't go through 3 atomizers as week.

 

[robl45]

i stuck an allen wrench through the bottom and pushed up on the bridge a little moving the assembly up slightly, no more clogging.

 

[Guineahill]

i stuck an allen wrench through the bottom and pushed up on the bridge a little moving the assembly up slightly, no more clogging.

Wonderful! You have discovered a new trick for people to try when they have issues with atties. I have added this one to my atty rescue routine!

 

[robl45]

Wonderful! You have discovered a new trick for people to try when they have issues with atties. I have added this one to my atty rescue routine!

the only problem is i've only tried this on attys that i've pretty much already destroyed. so i'm not sure if it did any other damage to the attys. it didn't break the wires because it still heats up so i'm assuming it should work fine.

 

[Switched]

the only problem is i've only tried this on attys that i've pretty much already destroyed. so i'm not sure if it did any other damage to the attys. it didn't break the wires because it still heats up so i'm assuming it should work fine.

... you mean you haven't tried it yet

 

[robl45]

i have tried it, but my attys were to the point of barely working. i didn't have any good attys that are clogged.