Atomizers ruined for 3.7v after using on a pass-thru

[embryo]

I'm using BE112's. Several of my atomizers worked great with batts, but after using them on my pass-thru for a few days, they will ONLY work on the pass-thru....it seems that there's not enough power in a batt to heat it up anymore :-(

Has anybody else experienced this?

 

[CellWho]

I had this problem with a 510 pass through. It turned out to be the center piece on the atomizer that connected to the battery. I had tightened it too much and the pass through pushed it in. I used an eye glasses screw driver, put it into the whole, and pushed it back up.

Hope it helps.

 

[Jim Davis]

The contact was probably pushed down. Instructions for fixing this are in my sig.

 

[Stike]

Contact problem be careful when trying to adjust contact