Attack of the Hana Modz Clone. Let's wait together!
- Thread starter Fathomrock
- Start date
- th_trl_thread_readers 0
- Status
That's some kind of record, tks for that. It would be great to find out what caused the failures.
My two, other than the occasional extra click required to wake up all behaving nicely, quite satisfied with my purchases.
The wife's runnin' the crap out of her's without any problems.
Mine is used in rotation so not much heavy use.
Both are being used with 0.8Ω coils set to 22 watts which actually gives 20 watts.
The wife's runnin' the crap out of her's without any problems.
Mine is used in rotation so not much heavy use.
Both are being used with 0.8Ω coils set to 22 watts which actually gives 20 watts.
Last edited:
Got my black one a couple of days ago, working good so far! quick question. Do you guys screw your atty's all the way down till it stops and can't turn anymore or just till it makes contact with the center pin?
Mines reading about .5 ohms lower than what it should. Other than that just as the quirkiness others have posted. Finger Magnet Big Time (Black)
I believe about an 1/8 turn after contact is pretty much the suggested procedure with these type of 510 sockets. Too tight and you may split the grommet under the 510's center pin resulting in a short.
two finger, just not wobbly snug. be sure any atty your going to use has a protruding center pin. the positive contact on the modz 510 is oversized and any flush or slightly recessed center pin will cause a direct short.
0.5ohms off?! That's no good! That's a BIG problem imo... Mine will round down 0.1ohm if it's not past, say a 0.08ohm threshold.... And even that's on 0.8ohms and higher... Below that I'm getting spot on readings...
I don't have the slightest clue as to why some are getting phantom screen and "locked in locked mode" issues... I'm assuming short protection was not implemented properly on some of them though... Mine, DEFINITELY has it, day one I was trying all my toppers, before the lemons started appearing, and I have an old hyper tank with the pin sitting flush, screwed it down a bit too much, tried to fire, it displayed shorted, unscrewed it just a bit and fired... So in conclusion, I'll say China's QC is China's QC...
101vape.com Clones (all colors) in stock as of 10PM.
Order now if interested. ($69.00, reasonable shipping- $3.00)
Order now if interested. ($69.00, reasonable shipping- $3.00)
Yeah it's huge, think I'll wait till my elev8 one gets here and let wetvapes know beforehand and see if they'll replace it.
A Kutech case for an iPhone 5 5S 5C 5G w/ Otterbox / Lifeproof Case On from Amazon. About $10 and is very well constructed. Works with clone and a dripper, just fits. Set the clone at angle for the case top to close with atomizer or drip tip sticking out.
Mine has it as well, just shows "shorted" if I short the 510 out with tweezers. Fires almost every time coming out of sleep mode on 1 click.
Everything else works fine
Tempted to take the cover off over the wiring.
Tks for the updates on non bricked Mods.
Everyday for three weeks and still working, use of 1 1/2 - 2 full charges/day.
- Status
