Attack of the Hana Modz Clone. Let's wait together!

Link deleted..... sorry classy.....

 

That's for the Mini, retird. There's also a test to see if people have a possibly defective unit.

 

My first batch illvapes clone is still going strong. No issues. My only issue with the clone was having to read alarmist crap in the thread. Let the thread die...

 

I'll second that.

 

Interesting..... what is this test you mentioned.....guess I've not seen it....

 

There's a thread about the device you're spamming this thread with warnings about. Cloupor Mini Mod 30W

 

Fire it at 30w for 15s (cut off). If you get a "too hot" message on the display, return to vendor.

 

edited.....thx ktm......also found the answer I pm'ed ya about...

 

5 months in and mine is officially on the "only use in absolute emergency" lineup (not likely, I still have mechs) because about a week ago it woke me up in the middle of the night because it was auto-firing.

and being that my DNA40 lasted a week before going caput, I am declaring Yihi the undisputed (in my anecdotal experience ) champion

 

Hi,
I have an Cloupor Hanna clone that is about 6 months old. Here recently I am getting a few "Check Atomizer" messages and I crank down a little harder in the atty to make the connection. I had a MVP that would do this and I was able to tease out the center pin with a mini screwdriver. So far my attempts to get the center pin have not been successful. Has anyone had a similar experience and if so, how did you remedy the situation?

Thanks for your input.

 

The stock 510 has a very short pin (~5mm). You could wiggle it up a bit but be very careful. The bushing holding the pin is pretty hard.

The MVP has a much longer pin (20mm) so there's less chance of damage.

 

Thanks, but I am not having any luck getting it to work for more than a few hours at a time. I guess I could order out a Fatty Daddy 510 connection, but the Cloupor is so full of hot glue that I think I will have more problems. I do not know how to solder. I guess it is time to start thinking about something to replace this with.

Thanks again.

 

Soldering isn't hard mate. A basic iron and some solder is cheap. Youtube is your friend.

 

I've had my Hana modz clone for almost a year now and it still works great. Ohm meter is off by about .1 but that the only draw back. I'm still loving it.


Sent from my iPhone using Tapatalk

 

I guess I will give it a go. I have a friend that has a simple soldering iron. Maybe he will help. Anybody know whick fatdaddy 51o is best on this clone. The V4 mshort or V4 Low Profile?

Thanks

Never mind. FDA suggests the V3 wood and I added the 22mm washer.