Atty sogging out

[Sovrin]

Hi guys
Approx 1 week ago i recieved my Ego-T from vender and everything great, lots of taste and vaper.
Now after a week my vape and taste has been greatly reduced, one thing i have noticed that the atty seems bog out with too much ejuice, what is the problem there? my remedy is to take the tank off and puff a few times without it and it makes a sizzleing sound. this also same with fully charged batts.
any response thanked.

 

[tyleris12]

Maybe try a new tank, as yours may be allowing too much juice to get into the attie. I've had that happen and usually a new plastic tank will solve the problem.

 

[Sovrin]

Thanks for answering, will try that.

 

[robert shohet]

of course try blowing out the atty just blow hard thru the threaded side to drain excess juice it will drip thru the wick normally that fixes im ills if not tyleris 12 is very helpful

im vaping while az burns

 

[DowneastMaine]

I have switched to tanks with a silicone base and no more problem!

 

[Flying W]

where can I get some silly base tanks?

 

[jj2]

You've flooded it. Take it off and blow through the threaded end.

 

[MasonD]

Careful, you don't want to dry-burn the atty unless you've removed the wick-plate, lest the wick melts to the atty.

The wick does tend to collect build-up, producing a poorer vapor after about a week or so, depending on your juice. A good cleaning will help-- there's a couple of vids around on it, but an ultra-sonic jewelry cleaner is supreme (42000 Hz): http://www.e-cigarette-forum.com/fo...rasonic-cleaning-atomizers-very-best-way.html

If you're into fiddling with stuff, you could try the wick-mod-- I've found that all of my stock wicks failed eventually (as in soon-ish type of eventually...), leaking and flooding and generally being too wet. You could move the stock wick up or down in the wick spike, but after figuring how to do the wick mod, my eGo-t is about as reliable as I think it could be! (if you go with the mod, be sure to read the whole post, and use far less ptb than you think you need, and pack some patience; but once you get it down, it's golden...) http://www.e-cigarette-forum.com/forum/ego-type-models/169520-simplecjs-ego-t-wick-mod.html

Cheers

 

[Mickey3Gun]

I have switched to tanks with a silicone base and no more problem!

Just picked some up from CIGNOT. https://www.cignot.com/product_p/egt-sil-cpa.htm They look promising! No leakage, so far. You just use them to replace the existing plastic cap on the base of the "A" model tanks.

 

[Gru]

I've had that happen only once when I left it semi-upright in the cup holder of my car. Since then I leave them laying flat when not in use, and I've never had that problem again.