Attys help

[christophermac]

I have 3new Attys one has a hard drew with like no vapor the other 2 taste like they are burning please help no matter what what volt I have them on in my ego twist

 

[steved5600]

Need the resistance of the attys the ohms rating.

 

[christophermac]

The one with a hard drew a and no vapor is a smoke teck 1.5 lr and the other ones are Vision 510 Steel Hybrid Atomizer one is 1.5 other is 2.0

 

[JessyDrastic]

you blow the primer out of em..?
that stuff can taste pretty yuck.

 

[christophermac]

Yah I did I try ed rubbing alcohol. And everything

 

[Drako60]

rubbing alcohol is bad, very bad for your health, try blowing them out, run water though them blow them out again to make sure they are good and clean, if you have vodka or everclear you could try that as well. Also do not dry burn them that would also make them taste bad.

I haven't used those particular atomizers but you may not be getting enough juice in them, try flooding them the first time after you get them clean, then just keep dripping when the flavor fades.
I know with 306 atomizers i have to basically run them flooded or near flooded all the time to perform like i want them too.

As for the one that has a hard draw, check the air holes around the bottom to make sure there is nothing in them, also some can be adjusted with the center pin and a small screw driver, but do not force it if it doesn't easily turn or you could ruin it completely.

 

[christophermac]

I have tried everything I I'm flooding them every time they are clean I'm using good juice

 

[dDubs]

Make sure your voltage isn't turned up too high

 

[christophermac]

It's only on 3.5 volts with the 1.5 ohm and the 2.0 is at like4.1