Attys vs carts vs tanks

Status
Not open for further replies.

scorch

Full Member
Nov 2, 2012
39
13
California
I use mini novas with either 1100mah KGO or 1300mah Vision Spinner. I have tried dripping, seemed like too much effort for too little benefit. I have used the 2 piece atomizer/cartidge set up. That worked OK, nothing to write home about though. I have some Boge cartos on the way. Curious to try those. I am guessing that they will be similar to the atomizer/cartridge setup.

So far, the mini novas just seem to work. They don't leak (unless they end up upside down), are easy to fill, taste fine (to me), and are pretty cheap. I am not sure that they actually use more juice, because I am positive that they do not hold what they say they hold. Either that or my 3ml samples from HHV are actually closer to 5ml.
 

voodoocharlie

Unregistered Supplier
ECF Veteran
Aug 16, 2012
356
204
Woodbridge, Va
All of the above.

The ATTY I use is a RBA (rebuildable atty) I use Stainless Steel wicks I love the taste and Vapor production out of this device

Carto's Hated them cause I couldn't see how much Liquid I had left so I punched some holes in them and threw them in a tank

tanks Love it I can see the amount of Liquid I have left. and I don't have to drip 3 drops take a few toots and drip some more

Thats my opinion and I hope it helps
 

BikerBob

Super Member
ECF Veteran
Verified Member
Jul 16, 2012
341
167
VA
Phoenix-clone rebuildable atty, with Stainless Steel vertical wick, for when I just want a short vaping session of a particular e-liquid (and for test-tasting new flavors) Easy to clean between flavors.

Carto-tank, vivi-tank, mini-did-clone, clearomizers--each seems to add its own nuance to the flavor I'm vaping, as does the wicking (SS vs cotton vs silica). Depends what I'm in the mood for at that time. Each has its own quirks for keeping e-liquid at a consistant feed to the coils (twirl, invert, keep horizontal/vertical, etc.).

Have plain cartos available, if I need a smaller profile for stealth vaping. Also used as emergency backup. Not my preferred way to vape, as cannot see liquid level, and doesn't feed liquid to coils at a consistant rate, and sometimes bothersome need to top-off.
 
Status
Not open for further replies.

Users who are viewing this thread