baby egos

Status
Not open for further replies.

Kent C

ECF Guru
ECF Veteran
Verified Member
Jun 12, 2009
26,547
60,051
NW Ohio US
Do you know the length of the mini T3? It looks smaller than the CE5 and the EVOD which is great.
And you can replace the head with any T3's head?

The baby t3 and evod are about the same size - perhaps the Baby T3 is a tad shorter, but the more tapered mouthpiece looks slimer, imo. And I like it better than the evod mouthpiece - that's a subjective choice. But the capacity listed is 1.7 ml for the Baby T3 and 1.6ml for the evod. The Baby T3 takes regular T3 heads - I know because I've done that - put the T3 1.8 in the Baby. The evod heads are not the same, close to the protank's and a bit cheaper. I bought t3 heads bulk so I'm in that range ;)
 

Kent C

ECF Guru
ECF Veteran
Verified Member
Jun 12, 2009
26,547
60,051
NW Ohio US
Found this website that sells them in the uk.
KANGER MINI T3 BOTTOM COIL CLEAROMISER

It says
SINGLE UNIT INCLUDES 1 COIL
BUNDLE UNIT INCLUDES 4 coils (adding £5.50)

As I'm quite ignorant in the subject, what is the coil? The head?

Yes. The changeable coil (CC) is the head with the knurled piece along with the coil/wick/stem..... that screws onto the tank part - must be tight or you will get leaks. You fill 'upside down', unlike the top coils types so you have to turn the PV upside down to unscrew and refill. I usually leave the coil unit on the batt when refilling. Don't drip in the center post/shaft.....
 

slideaway

Full Member
May 4, 2013
49
1
London, UK
I think the bottom coil of the Kanger T3/evod/protank works better than the top coils. For the eGo mini, the Baby T3 is a good match, imo. 1.7ml capacity.

Baby-Kanger-T3-Line-up--300x300.jpg


Third from left - baby t3 with 450 mini ego...
149649000.jpg


I don't like the cosmetic metal skin of the evod (and the added weight), or the top coil of the CE's.

What about the second on the left? Is the joytech ego? I wanted to know if that kind of clearomiser is rebuildable? Definitely more confortable to carry in a pocket..and less noticeable
 
Last edited:

Kent C

ECF Guru
ECF Veteran
Verified Member
Jun 12, 2009
26,547
60,051
NW Ohio US
What about the second on the left? Is the joytech ego? I wanted to know if that kind of clearomiser is rebuildable? Definitely more confortable to carry in a pocket..and less noticeable

2nd from left is a joye 510 batt. That's a gold universal hybrid atty from Vapage with a drip tip - drip only so not for going out. The 450 mini with the baby t3 is a good combo for stealth. Only a little bit bigger than my 'hand' picture with the mini and the cone.
 

Mark408

Senior Member
ECF Veteran
Apr 2, 2013
94
74
San Jose, Ca
I have 4 mini ego batteries. Make sure you get that is 400/450 mah. The only one that dies on me if the 350 mah before I get home from work.

Here's a pic of my "mini" ego w/ 480mah batt from Vapors Choice:
picstitch.jpg
This batt def. out performs the 350mah batt I use to have. Much perfect for on the go "stealth" vaping. This is my most used setup when I am not home.
 
I have a 400 mah mini e-Go from Innokin with their "stop light" battery power indicator button. I bought it as a back up and i end up using it all the time and more than some of my twists and spinners. It's perfect for testing juice/dripping. its just a little bit shorter and a little bit wider than my 510 esmart but it lasts longer and packs way more punch it feels like pushing the same carto's at 2 ohms (with a mini less than 450 i wouldn't go lower even to 1.8 imo,)...and a Inno mini and a 510 esmart clearo you don't get much more of a powerhouse in a compact size. I haven't been able to find the inno one's anywhere since i stopped in that shop on that rainy day to grab a tank when I cracked one and was caught without a spare. But if you can find that Inno mini buy it,,,it's worth every penny and just as high quality as the more common high end Innokin VV stuff you see everywhere.

Happy Vaping :toast:
 

nttdemented

Super Member
ECF Veteran
Verified Member
Aug 15, 2013
403
344
San Juan, PR
I've been using my two Minis with 1.7 ohm microcoils in my EVODs with great success the past week or so. Been very happy with them for the purpose I'm using them for. I still walk around with my Mech Mod and Kayfun as I use my favorite juice in there but for an occasional hit of Custard, Apple Pie, etc... These are working marvelously!
 
Status
Not open for further replies.

Users who are viewing this thread