Best RTA for Flavor on a mechanical?

[Yepix]

Im looking for an rta that has great flavor, vapor production doesnt have to be good.

I will be using this on a mechanical, so It must work well with .5 ohm builds.

Current contenders:

- EHPro kayfun Lite Plus Clone

- Lemo

 

[retic1959]

Im looking for an RTA that has great flavor, vapor production doesnt have to be good. I will be using this on a mechanical, so It must work well with .5 ohm builds. Current contenders: - EHPro kayfun Lite Plus Clone - Lemo

I would suggest you check out the Rose , I'm running mine with a .36 Gplat build on a copper stingray . I have kayfuns but they're not good for subohm builds , the Rose has juice flow control on it allowing it to keep up with a hot build as far as wicking goes and my Rose's easily beat my kayfuns in flavor delivery . Between the juice flow control , ceramic cup and peek insulaters the Rose is made to run hot . http://www.smokenmist.com/product/rose-v2-stainless-steel-tank-clone-hcigar/

 

[politbureau]

I second the Rose v2, and will add the Orchid v4. I have both, and both deliver roughly similar flavour, tho the Orchid is airer and produces better vapour. You have to wick more carefully on the Orchid due to the tight build deck, but I've run 80/20 juices without issue.

Have you considered the Big Dripper? Because it's essentially a dripper with a tank on top, you get dripper quality flavour and it will hold 5ml when filled correctly. It also produces massive amounts of vapour, and has all but replaced the tanks in my collection. I'm just waiting for them to come out with one that has a center glass section so you can see how much fluid you have left

 

[bholcomb22]

I have both of those devices and love them both....

My eh pro kayfun lite plus v2 is my ADV. I actually haven't touched my Lemo in a while...

 

[nasca]

going that low on a kayfun can be dicey. insulators can melt and there is limited airflow and the very thin liquid channels can have trouble keeping up.

check out the big dripper or erlkonigin.

 

[bholcomb22]

Oh i didn't see the .5 ohm thing. Get the Lemo.

BUT...... The kayfun performs fantastic on a mech between 1.2 - 1.3 ohms

 

[loll88]

I build my fogger v4.1 to be .8 ohms but did went down to.4 ohm before, although I drilled out the air holes to match the size of the air holes on the build deck, also removing the air flow control ring. Good flavor and vapor production.

 

[roxynoodle]

I've had my Lemo down to 0.5 ohm. One Rose is at 0.7 and no doubt one could go lower.

Orchid, Fogger or the new Billow might interest you.

 

[t8kiteasy]

Taifun GT works well at .3-.5 with excellent flavor though the air flow is not airy it does produce above average vapor.

 

[1mouse3]

you could also seek out genny's like the kraken, the orchid isnt bad ether