Like resurrectors for example.. I use condom for my standards like boges. I do that with the resurrectors and I get the burnt taste premature sometimes. I even top it off before use. One idea was to do a few condom fills before use. Any suggestions?
Best way to fill larger than normal cartos?
- Thread starter Butters78
- Start date
- th_trl_thread_readers 0
- Status
Patience really .
Fill them slowly until the don't take any more juice .
I also pre-fill them and let them stand upright for a couple of hours before using.
Fill them slowly until the don't take any more juice .
I also pre-fill them and let them stand upright for a couple of hours before using.
Thanks hoss, I think I am too impatient haha.. its well worth it though considering they last a good amount longer than standard size. I still haven't taken the tank plunge yet but can't wait.
The best way I've found to fill ressurectors is to gently place a toothpick in the center hole just enough to keep juice from going in there. Then just drop in a little at a time. You can actually put more than usual in there because the hole is "safe". It soaks in pretty fast. Just do this in chunks until it drops out the battery end/can't hold anymore. It makes it so much quicker than holding it at a 45 degree angle, gently dripping a few drops at a time, etc... You can dump about 6 or 7 drops at a time, and it evenly soaks in because the covered center hole makes the liquid pool up entirely, surrounding it. It then just slowly soaks perfectly in, little by little. It works flawlessly. I'm actually surprised this isn't a well known filling technique.
Now, if you're trying to use 100% vg filling a boge carto, this probably wouldn't work, because the thick liquid would just sit there and not soak into the very dense filler.
But most liquids seem to be mostly/all/or at least half pg, and the smoktech filler isn't as dense, so this technique works well.
Now, if you're trying to use 100% vg filling a boge carto, this probably wouldn't work, because the thick liquid would just sit there and not soak into the very dense filler.
But most liquids seem to be mostly/all/or at least half pg, and the smoktech filler isn't as dense, so this technique works well.
...keep in mind Resurrectors take 2ml of juice to fill...I ustta use a syringe to fill these to ensure proper filling but I just drip fill them now...they will take around 60drops to completely fill..........
madjack
p.s. if you use a high VG ration juice(above 50%) you will almost havvta use a syringe to fill or it will take a week or so to fill completely....mj
madjack
p.s. if you use a high VG ration juice(above 50%) you will almost havvta use a syringe to fill or it will take a week or so to fill completely....mj
I have some long dual coils and use the condom method to fill them. I let them soak and then refill the condom and go through the process again. I haven't used a resurrector, but the condom method works with a double fill for longer cartos. I like the toothpick method, too. I hadn't heard of that, but it makes perfect sense.
For large cartos I use the syringe too. Condom method is great for Boge or even mega DCC but any bigger like the Ego Mega DCC or the XXXL or bigger, I'd use a syringe for sure. don;t think you even could use a condom method for those since they don't come with them when they're that big.
I use a syringe. Stick it all the way down into the side of the filler and fill. vape immediately.
I used to repeat the condom method over and over, now use the syringe method with straight vg, longer cardos, and vape at once as well, this is the fastest way, i find mysely switching over to tanks though, only drawback, i think it screws up the flavor on my BOBAS BOUNTY JUICE...
- Status
Similar threads
- Locked
