Love the igo-s. THis is a great little rebuildable dripper. Just
vape, rinse, dry with paper towel, add another flavor and
vape. Takes all of 30 seconds. Has a small lip at the base so it can hold more then your average dripper.
IGO-S Rebuildable Mini Stainless Steel Dripping Atomizer
Thanks for the suggestion
based on your recommendation, I bought a couple of `em
This is a perfect solution to testing multiple flavors !.....I like this design much better than my bridgeless atty
..much easier to clean and dry...small,but large enough to have a similar draw/temperature to my clearomizers
_________________________________________________________
It was my first try at wiring a coil and I screwed up one, but got the other running nicely
To anyone who may be in the same boat as I was, here`s where I went astray:
The wire will snap if you torque the set screws down too far
.it will take some pressure, but can reach a point of failure
.after my wire visibly crimped down,I kept torquing the set screw ....and snapped off both ends of the wire
_____________________________________________________________________
Here`s how you can get a feel for how tight to drive the set screw
.and still have enough wire left for a working coil
Insert one end of the supplied wire into the post hole
just far enough to extend about a sixteenth of an inch thru the other side
Then tighten down the set screw until the wire snaps off
This should familiarize you with just how much force is ideal,and how much is too much, for a successful install
.and your wire will still have plenty of length to make a nice coil
