Billow v2
- Thread starter Skillvillain579
- Start date
- th_trl_thread_readers 0
- Status
Don't have the Goblin, but the Billow V2 is amazing. Not as much vapor as an rda, but just as much flavor. It feels like an on-the-go RDA instead of an RTA. Just a bit of a pain to build, as all RTA's are tiny. Blow's the Delta II RTA deck out of the water! Honestly beats the standard coils for the Delta II as well.
I am very interested in the Billow V2 RTA. I love RTAs over all other style atomizers and this one looks like it would be my go to tank.
I just got mine a couple days ago, did my first build, just using the included .6ohm coils and japanese cotton.
I'm halfway through a tank of MilkMan. Got a little burny at like 45 watts, will mess around with other wicks next build.
The flavor thus far isn't as good as my uwell crown with purchased atomizers, but it's good. I'm sure it needs more breakin too, and probably better wicking, I'm still trial and error-ing how dense to make the wicks.
I do NOT have a single bit of leakage, I angle-cut the tails and fed the points into the juice channels before putting the top on, works perfectly.
Thus far, not going to replace my crown, but I DO love to tinker, I may pull the wicks out tonight and try looser wick, see how that does for flavor and wattability.
This is a very well built tank, no more bulky than it needs to be, great airflow, very sharp. Love that I CAN pop off the bottom, work on the wicking, put back on rather than wait until I"m empty or anything.
I DO wish it had velocity style posts, rather than the 2 outside, 2 inside, but it's not that big of a deal. Also wish it came with slightly heftier screws, I can see them becoming a problem eventually.
All in all, this is a great piece of work, not replacing my Uwell Crown tanks yet, but may replace the Tobeco Super Tanks, or at least be pulled before them!
--Alex
I'm halfway through a tank of MilkMan. Got a little burny at like 45 watts, will mess around with other wicks next build.
The flavor thus far isn't as good as my uwell crown with purchased atomizers, but it's good. I'm sure it needs more breakin too, and probably better wicking, I'm still trial and error-ing how dense to make the wicks.
I do NOT have a single bit of leakage, I angle-cut the tails and fed the points into the juice channels before putting the top on, works perfectly.
Thus far, not going to replace my crown, but I DO love to tinker, I may pull the wicks out tonight and try looser wick, see how that does for flavor and wattability.
This is a very well built tank, no more bulky than it needs to be, great airflow, very sharp. Love that I CAN pop off the bottom, work on the wicking, put back on rather than wait until I"m empty or anything.
I DO wish it had velocity style posts, rather than the 2 outside, 2 inside, but it's not that big of a deal. Also wish it came with slightly heftier screws, I can see them becoming a problem eventually.
All in all, this is a great piece of work, not replacing my Uwell Crown tanks yet, but may replace the Tobeco Super Tanks, or at least be pulled before them!
--Alex
- Status
Similar threads
- Locked
