Blinking kGo light

[Pipe_Dream_321]

So when I ordered my kGo setup I order a 1.5 ohm atty and it was working great. Then about two weeks in it started blinking when I went to vape.
My buddy told me the atty was probably going bad. So he gave me an i06 from iKenvape. Clouds of vapor!! So it's been a week now and I am getting the same quick three blinks and no vapor!!

Help!!!

 

[Yves]

Try popping up the centre post on the battery a very small amount use a small screwdriver or a paper clip.

 

[Vapoor eyes er]

Also make sure the connection areas on your batt and atty are clean and free of juice. Also may be a short in your atty. Sometimes you need to reset the Kgo- click 5 times to turn off and then 5 times to turn Kgo on.

 

[cdunn96]

I had a similar problem where it would work with atty and not certain carto and tank, got a hold of company and they had me adjust that little plate where battery contacts device with tiny screwdriver, I barely touched the plate moving it a very tiny bit and it has worked great since. I guess the plate can get pushed down a little bit with certain things. Do not use lot of force a very tiny bit.